Abstract:An atmospheric argon plasma jet generated by an original dc double anode plasma torch has been investigated through its electrical and spectroscopic diagnostics. The arc instabilities and dynamic behavior of the argon plasma are analyzed using classical tools such as the statistical method, fast Fourier transform (FFT) and correlation function. The takeover mode is identified as the fluctuation characteristic of the double arc argon plasma jet in our experiment. The FFT and correlation analysis of electrical signals exhibit the only characteristic frequency of 150 Hz, which originates from the torch power and is independent of any change in the operating parameters. No high frequency fluctuations (1-15 kHz) are observed. This indicates that the nature of fluctuations in an argon plasma jet is induced mainly by the undulation of the tri-phase rectified power supply. It is found that each arc root attachment is diffused rather than located at a fixed position on the anode wall. Moreover, the emission spectroscopic technique is performed to determine the electron temperature and number density of the plasma jet inside and outside the arc chamber. Along the torch axis, the measured electron temperature and number density of the double arc argon plasma drop from 12 300K and 7.6 x 10(22) m(-3) at the divergent part of the first anode nozzle, to 10 500K and 3.1 x 10(22) m(-3) at the torch exit. In addition, the validity criteria of the local thermodynamic equilibrium (LTE) state in the plasma arc are examined. The results show that the measured electron densities are in good agreement with those calculated from the LTE model, which indicates that the double arc argon plasma at atmospheric pressure is close to the LTE state under our experimental conditions.

Optical and Electrical Diagnostics of Cold Ar Atmospheric Pressure Plasma Jet Generated with a Simple DBD Configuration

Optical and Electric Diagnostics of DBD Plasma Jet in Atmospheric Pressure Argon

Effect of the Grounded Electrode on Cold Ar Atmospheric Pressure Plasma Jet Generated with a Simple DBD Configuration

Optical and Electrical Diagnostics of an Atmospheric Pressure Room-Temperature Plasma Plume

Dbd Plasma Jet In Atmospheric Pressure Argon

Electrical and Spectroscopic Diagnostic of an Atmospheric Double Arc Argon Plasma Jet

Optical and Electrical Diagnostics on a Long Atmospheric Pressure Cold Plasma Plume

A Simple Cold Ar Plasma Jet Generated with a Floating Electrode at Atmospheric Pressure

Investigations on an Atmospheric Dielectric Barrier Discharge Plasma Jet with a Concentric Wire-Mesh Cylinder Electrode Configuration

Atmospheric Pressure Cold Argon/oxygen Plasma Jet Assisted by Preionization by Syringe Needle Electrode

Study on the Influence of Dielectric Barrier Materials on the Characteristics of Atmospheric Plasma Jet in Ar

Electrical and Spectral Characteristics of a Low-Temperature Argon–Oxygen Plasma Jet with Syringe Needle-Ring Electrodes

Electrical and Spectral Characteristics of an Atmospheric Pressure Argon Plasma Jet Generated with Tube-Ring Electrodes in Surface Dielectric Barrier Discharge

Investigation of discharge characteristics of DBD plasma produced with multi-needle to plate electrodes in water by optical emission spectroscopy

An Uniform DBD Plasma Excited by Bipolar Nanosecond Pulse Using Wire-Cylinder Electrode Configuration in Atmospheric Air.

Characteristics of Low Power Ch4/Air Atmospheric Pressure Plasma Jet

Temperature verification of the cold plasma jet generated by atmospheric dielectric barrier capillary discharge

Cold Atmospheric Plasma Jet Sustained with Nanosecond Voltage Pulses

A Filamentary Plasma Jet Generated by Argon Dielectric-Barrier Discharge in Ambient Air

Optical diagnostics of a low power—low gas flow rates atmospheric-pressure argon plasma created by a microwave plasma torch

Characterization of DC argon plasma jet at atmospheric pressure