Abstract:Effective thermal conduction between solid interfaces has emerged as a major bottleneck in heat dissipating heat from new-generation high-performance electronics. Gallium-based liquid metals (LMs), known for their high thermal conductivity, are gaining significant traction as thermal interface materials (TIMs) for enhanced thermal management. In this work, to address the key issues facing the application of gallium-based LMs as TIMs, including the lack of composition ratio data, poor coating performance and the need for improved thermal conductivity, two types of gallium-based LM-TIMs (Ga-In binary LM-TIMs and Ga-In-Sn ternary LM-TIMs) with different composition ratios were experimentally prepared, investigated and optimized. The thermal conductivities of the LM-TIMs at different temperatures (80 - 120 ℃) were tested, and the application reliability of the LM-TIMs was optimized by continuously destructing the oxide layer and filling micro copper particles. The influence of optimization parameters such as the duration of the destruction of oxide layer, the filling ratios of the particles and the particle size on the operation performance of the LM-TIMs was studied and analyzed. The results showed that the LM-TIMs exhibited excellent thermal conductivities of 29.6 - 38.5 W/(m·K), and the thermal conductivity increased with indium mass fraction and decreased with tin mass fraction. Significant improvements in coating performance were observed with the increase of the duration of destructing oxide layer, but it led to a reduction in thermal conductivity. Balancing coating performance and thermal conductivity, it was found that 30 min was the ideal duration. The filling of micro particles made up for the reduced thermal conductivity, and higher filling ratios and smaller particle sizes achieved better enhancement. In the experiment, a filling ratio of 5 % was appropriate because solidification occurred in LM-TIMs at higher filling ratios which weakened the thermal conductivity. This work provided valuable reference for the application and optimization of high thermal conductive gallium-based LM-TIMs.

Experimental Investigation of GaInSn Current Limiter Based on a Novel Principle

Experimental Investigation on Optimization of the Performance of Gallium-Based Liquid Metal with High Thermal Conductivity As Thermal Interface Material for Efficient Electronic Cooling

A Novel Liquid Metal Fault Current Limiter Based on Active Trigger Method

Experimental Study on the Solid-state Fault Current Limiter with Bypass Inductance

Investigation of a Double Current-transferring Type Short Circuit Current Limiter

Experimental Investigation on Liquid-Metal Flow Distribution in Insulating Manifold under Uniform Magnetic Field

Investigations of leakage current properties in semi-insulating GaN grown on Si(1 1 1) substrate with low-temperature AlN interlayers

Study of the Leakage Current Mechanism in Schottky Contacts to Al0.25Ga0.75N/GaN Heterostructures with AlN Interlayers

A Novel Six-Leg Three-Phase Fault Current Limiter

Saturated-core fault current limiters for AC power systems: Towards reliable, economical and better performance application

Research on the dynamic characteristics of the electromagnetic repulsion mechanism of a self-driving fault current limiter

Experiment and research on control strategy for a new-type three-phase solid-state current limiter

Investigation of Conductivity Modulation in Vertical GaN-on-GaN PiN Diode under High Current Density

Design and Test of a Magnetic Saturation‐type Fault Current Limiter

Studies of YBCO Strip Lines under Voltage Pulses: Optimisation of the Design of Fault Current Limiters

STUDY ON THREE-PHASE MAIN CIRCUIT TOPOLOGY AND CONTROL STRATEGY FOR A NEW-TYPE SOLID-STATE CURRENT LIMITER

Effect of Direct Current on Solid-Liquid Interfacial Tension and Wetting Behavior of Ga–In–Sn Alloy Melt on Cu Substrate

Research on a Novel Bridge-Type Fault Current Limiter and Its Control Strategy

Experimental Research on the Thermal Characteristic of Low-Voltage Alternating Current (AC) Arc Faults

Investigation and active suppression of self-heating induced degradation in amorphous InGaZnO thin film transistors

Investigation on Dynamic Characteristics of AlGaN/GaN Lateral Schottky Barrier Diode