Abstract:Open Radio Access Networks (Open RANs), realized fully in software, require excessive computing resources to support time-sensitive signal-processing algorithms in the physical layer. Among them, multiple-input-multiple-output (MIMO) processing is a key functionality used to drive higher connectivity in the uplink, but it is computationally intensive, triggering the need for hardware acceleration to overcome the processing inefficiency of software-based solutions. Additionally, energy efficiency is becoming a key focus in Open RAN to enable sustainable deployments that utilize available resources efficiently. Because channel-inversion complexity increases polynomially with the number of users in linear detectors, such as zero-forcing (ZF) and minimum-mean-square-error (MMSE), acceleration based on channel-inverse approximations has gained significant attention. However, they unnecessarily multiply the number of base station (BS) antennas to ensure accurate detection, leading to a drastic increase in power consumption owing to the additional radio frequency (RF) chains employed. In contrast, linear detectors achieve a sufficiently good performance with only twice the number of BS antennas as users. This work introduces an exact-MMSE and soft-output hardware accelerator that includes an inversion-free, highly-parallel QR decomposition (QRD) architecture and a low-complexity detector stage with per-cycle soft-output generation, significantly improving the processing latency and throughput. The proposed architecture is fully scalable to support diverse MIMO configurations. Implementation evaluations on a Xilinx Virtex Ultrascale+ field-programmable gate array (FPGA) demonstrate that the proposed exact solution can achieve more than improvement in hardware throughput over existing approximate designs. Moreover, the peak throughput can be increased around 10-fold in slowly fading channels.

High Throughput MIMO-OFDM Detection with Graphics Processing Units

Expectation Propagation Based Iterative Multi-User Detection for MIMO-IDMA Systems.

Implementation of a High-Throughput OFDM System Using Graphics Processing Units

Design of Highly-Parallel, 2.2gbps Throughput Signal Detector for MIMO Systems

A Parallel Early-Pruned K-Best MIMO Signal Detector Up to 1.9Gb/s.

GPP-based Design of Soft MMSE MIMO Detection

MIMO Radar Parallel Simulation System Based on CPU/GPU Architecture

Energy- and Area-Efficient Recursive-Conjugate-Gradient-Based MMSE Detector for Massive MIMO Systems

Low-Computing-Load, High-Parallelism Detection Method Based on Chebyshev Iteration for Massive MIMO Systems with VLSI Architecture

An implementation of MIMO detection in TD-LTE based on General Purpose Processor

High-Throughput Accelerator for Exact-MMSE Soft-Output Detection in Open RAN Systems

MIMO Radar Hardware Acceleration with Enhanced Resolution

Hardware Efficient Signal Detector Based on Lanczos Method for Massive MIMO Systems

A 1.1-Gb/s 115-Pj/bit Configurable MIMO Detector Using 0.13- $\mu\hbox{m}$ CMOS Technology

Gaussian Message Passing Iterative Detection for MIMO-NOMA Systems with Massive Access

Physics-Inspired Heuristics for Soft MIMO Detection in 5G New Radio and Beyond

Low‐complexity receivers for massive MIMO‐GFDM communications

A 1 . 1Gb / s 115-pJ / bit Configurable MIMO Detector Using 0 . 13-μ m CMOS Technology

A 1.58 Gbps/W 0.40 Gbps/mm2 ASIC Implementation of MMSE Detection for $128\times 8~64$ -QAM Massive MIMO in 65 Nm CMOS

Low-complexity Multiuser Detection in Massive Spatial Modulation MIMO

Accelerating Channel Estimation and Demodulation of Uplink OFDM symbols for Large Scale Antenna Systems using GPU