Abstract:Numerical investigations of combined impingement and film cooling based on different turbulence models have been carried out and compared in the present study. The specific test case combines the complex flow physics of the jet impinging, turning and subsequent mixing with hot mainstream, which consists of jet shear layer separation, wall boundary layer transition, coolant jet detachment and reattachment. The turbulence models employed are the k  − standard, RNG, and realizable models, the k − standard, SST, and Transition SST models, and the t l k − k − model. Numerical tests have been performed at three representative blowing ratios from low to high for each turbulence model. The computed cooling effectiveness from  equation models tend to be underpredicted at low blowing ratio while numerical profiles of cooling effectiveness achieve considerable agreement with the measured experiment data at moderate and high blowing ratios. In addition, the computed results from  equation models reasonably match the measured data at low blowing ratio but cooling effectiveness are markedly underpredicted at moderate and high blowing ratios. In contrast, those results from the t l k − k − model agree fairly well with those of the experiment at various blowing ratios. Owing to the nature description of the pre-transitional streamwise fluctuations in the laminar kinetic energy, the solutions from t l k − k − model clearly reveal the complex flow physics in the combined impinging and film cooling in the confined region, where the jet shear layer separation, boundary layer transition, coolant detachment and reattachment co-exist. However, the large number of specified parameters in the t l k − k − model still needs to be further optimized to reach the enhanced agreement with experimental data and obtain extensive applications for combined cooling schemes.

LBE simulation of coherent vortex motion and heat transfer in jets of cross flow

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Effects of Flow Ratio of Transverse Jet on Flow and Heat Transfer : A LBE Study

Flow and Heat Transfer Characteristics in a Microchannel with a Circular Synthetic Jet

Numerical Study of Turbulent Jet in Cross-flow

LBE simulation of impinging stream inside a T-junction mixer

Numerical Simulation Of The Flows Over Two Tandem Cylinders By Lattice Boltzmann Method

Numerical Simulation for Flow Over two Circular Cylinders in Side-by-side Arrangement with Lattice Boltzmann Method

LBE–DEM Simulation of Inter-Phase Heat Transfer in Gas–solid Cross Jets

LBE-DEM coupled simulation of gas-solid two-phase cross jets

Simulation of Flows Around Two Tandem Rotating Cylinders in a Channel Using LB-DF/FD Method

Quantitative Investigation on the Formation of Counter-Rotating Vortex Pairs from the Inclined Jet in Crossflow

Large Eddy Simulation of the Inlet Cross-Flow in the CiADS Heat Exchanger Using the Lattice Boltzmann Method

A Lattice Boltzmann Subgrid Model for Lid-Driven Cavity Flow

Large Eddy Simulation of Energy Transport in Highly Compressible Transverse Jets

On Coherent Structures in a Three-Dimensional Transitional Plane Jet

Large eddy simulation of coherent structure of impinging jet

Formation and Evolution of the Flow Structure of an Inclined Jet in Crossflow

NUMERICAL INVESTIGATION OF DIFFERENT TURBULENCE MODELS APPLIED IN COMBINED IMPINGEMENT AND FILM COOLING

Numerical Investigation of a Gas–solid Turbulent Jet Flow with Reynolds Number of 4500 Using Lattice Boltzmann Method