Abstract:A novel design for a low dropout (LDO) voltage regulator is presented and dedicated to power many sections of a typical cellular handset. However, these baseband, RF, and audio sections have different requirements that influence which LDO is most appropriate. After discussion of the specific requirements, different LDOs are recommended. Also, some LDO design techniques are briefly discussed to demonstrate how an LDO may be optimized for a specific level of performance. Cellular phone designs require linear regulators with lowdropout, low-noise, high PSRR, low quiescent current (Iq), and low-cost. They need to deliver a stable output and use smallvalue output capacitors. Ideally, one device would have all these characteristics and one low-dropout linear regulator (LDO) could be used anywhere in the phone without worry. But in practice, the various cell phone blocks are best powered by LDOs with different performance characteristics. This paper provides a new design methodology to choosing the right LDO to power each cell phone and especially for the Voltage Phase-Locked loops (VPLLs) blocks. Fabricated in a 0.18 {\mu}m CMOS process, the measured results show the adopted topology achieves a better phase noise than the conventional saturation current source. and the spread of the current limitation (without matching) is 100mA, the VPLLs system demonstrates a phase noise of 782 nv/sqrtHz at 100-kHz, and 33 nv/sqrtHz at 1 MHz, while quiescent current 33 {\mu}A from a 2.6 V supply voltage.

A Low-Dropout Regulator with Low ESR, Low Line Regulation and High Currency Efficiency Using Low Output-Resistance Voltage Buffer

A Low-dropout Regulator with Low Quiescent Current and High Stability

Low-dropout regulator with no off-chip capacitor and ultra low power consumption

A Low-dropout Regulator with Unconditional Stability and Low Quiescent Current

A 300 mA 0.18 μm CMOS low-dropout regulator with high power-supply rejection

A Low-Power, High-Stability and Capacitor-Free LDO

Low Dropout Linear Regulator with No Off-Chip Capacitor and Low Power Consumption

CMOS Low-Dropout Regulator with 3.3μa Quiescent Current Without Off-Chip Capacitor

An Output-Capacitorless Ultra-Low Power Low-Dropout Regulator.

A Fast-Response Low-Dropout Regulator Based on Power-Efficient Low-Voltage Buffer

Design of low-voltage low-dropout regulator with wide-band high-PSR characteristic

An Ultra-Low Quiescent Current CMOS Low-Dropout Regulator with Small Output Voltage Variations

A 100 mA Low Voltage Linear Regulators for Systems on Chip Applications Using 0.18 μm CMOS Technology

A 3.6-μW sub-lV fast-transient-response output-capacitor-free LDO regulator in 0.13-μm CMOS technology

A Fully Integrated 1.8 V Low-Power LDO Regulator with Dynamic Transient Control for SoC Applications

A Capacitor-Less Low-Dropout Regulator for SoC with Bi-Directional Asymmetric Buffer.

A Low-Power Fast-Transient 90-nm Low-Dropout Regulator With Multiple Small-Gain Stages

A fast-transient high-PSR output-capacitor-free low-dropout regulator for low-power embedded systems

An External Capacitor-Less Low-Dropout Voltage Regulator Using a Transconductance Amplifier

A Fast Transient Low-Dropout Regulator with High-Power Supply Rejection

A Max 2.3μa Quiescent Current External Capacitorless Low-Dropout Regulator