Abstract:SoftCtrlDC-M is a control software designed to facilitate the development of a direct current (DC) motor driver by implementing core control code utilizing proportional (P) and integral (I) gains. At the same time, the P gain is dynamically updated using fuzzy-logic (FL) based on the Takagi–Sugeno (TS) model. This type of controller is called a fuzzy-logic controller (FLC), and the FLC is adept at accommodating non-linearities. Mechatronic systems often rely on DC motors and require high-precision positioning and accurate speed regulation. In the contemporary engineering landscape, stringent control requirements are needed throughout the system's lifespan. Researchers are actively exploring techniques to optimize gains through dynamic settings by adapting gains to system changes, while customers look for a system that provides comfortable and reliable operation. Soft computing contributes significantly to both areas, providing a framework for implementing a strategy that adapts gains to changes in system dynamics. This control software is available for reuse or execution in a microcontroller unit (MCU). This control software also met control requirements effectively and exhibited the benefits of using it at low shaft speeds (low speed represents a challenge for mechatronic systems since it requires the highest precision). The results of the test cases (groups) showed that the fuzzy-logic controller Takagi–Sugeno (FLC TS) exhibited less variability in five out of eight groups compared to the proportional–integral (PI) controller, representing a 62.5% improvement. Additionally, this proposed control method exhibited between 3% to 16% overshoot reduction compared to PI in high inertia testing and maintained the current speed within ±1 % in 100% of the cases contrasted to PI with 85%.

Fuzzy Logic Microcontroller Implementation for DC Motor Speed Control

Low Cost Control Method for Brushless DC Motors Based on Fuzzy Logic Controller

Design of Speed Control System Based on Fuzzy-PID Hybrid Control for DC Motor

The Simulation Analysis of Fuzzy Control System of BLDCM

BLDCM System Based on Fuzzy Control Technology

A MC9S12DG128B-Based Fuzzy Controller for Speed Regulation of a DC Motor

Speed Control of DC Motor Using Fuzzy PID Controller

Fuzzy Neural Network Applied in Sensorless BLDC Motor Control Based on MC56F8013

Development of Fuzzy Controller Using 8-Bit Microcontroller for Switch Mode DC Servo Motor Control

Network-based controlled DC motor with fuzzy compensation

An enhanced fuzzy controller based on improved genetic algorithm for speed control of DC motors

DC MOTOR FUZZY MODEL BASED OPTIMAL CONTROLLER

A novel SMC-fuzzy speed controller for permanent magnet brushless DC motor

Direct Current Motor Timing System Based on Piecewise Fuzzy Control

Direct Torque Control System For Induction Motors With Fuzzy Speed Pi Regulator

Transient Analysis of the Fuzzy Logic-based Speed Control of a Three-phase BLDC Motor

Close Loop Feedback Direct Current Control in Driving Mode of a Four Quadarnts Drive Direct Current Chopper for Electric Vehicle Traction Controlled Using Fuzzy Logic

Research on Circuit Design for Speed Adjusting Hardware of Brushless DC Motor Based on the Two-Dimensional Fuzzy Controller

SoftCtrlDC-M: Embedded control software for brushed direct current motors

Design of a DC motor speed control system based on single-chip

Application of FPGA in Speed-control of DC Motors