Abstract:This dissertation addresses the problem of path-tracking control of a mobile robot, also called an Unmanned Ground Vehicle (UGV), in Intelligent Space, where the controller is located on an entity different from the robot and communicates with the robot over a communication network. The involvement of a communication network leads us to the core of this research, the network time-delay factor. The existence of a network delay presents a challenging problem that might degrade the overall system performance and even destabilize the closed-loop control system. The existing research area for the aforementioned scenario is called Network-based control system (NBC) mostly focused on a general linear system for which the controller must be redesigned so that the overall NBC system can work properly. Distinct from the existing research, and innovative in its own right, the research presented in this dissertation focuses on a specific nonlinear system, the remote UGV path-tracking. More specifically, we focus on the methods that allow the existing workable path-tracking controller to be reused in the NBC environment. In this work, Accumulated effect parameter tuning method is firstly proposed to tune the geometrical path-tracking controller used in UGV before operating over communication network; then sensitivity analysis is introduced to consider how the system is sensitive to noise or perturbation so that the operating condition, such as UGV speed and path curvature, may be changed to limit the effect from noise or perturbation; afterwards, Feedback pre-processor (FP) is proposed to alleviate the effect of network delay by using UGV position estimation through UGV kinematics model; along with FP, UGV response time is proposed to demonstrate the effect of different UGV characteristics on path-tracking performance; finally, the effect of using Gain scheduler (GS) with two-dimensional and one-dimensional gain table is investigated for the capability to alleviate the network delay on remote UGV path-tracking.

Gain Scheduling Middleware for Networked Mobile Robot Control

Gain Scheduler Middleware: A Methodology to Enable Existing Controllers for Networked Control and Teleoperation—Part I: Networked Control

Neural Network Middleware For Model Predictive Path Tracking Of Networked Mobile Robot Over Ip Network

Model predictive path tracking via middleware for networked mobile robot over IP network

Impacts of Wireless on Robot Control: the Network Hardware-in-the-Loop Simulation Framework and Real-Life Comparisons

Gain Adaptation of Networked Mobile Robot to Compensate QoS Deterioration

Mobile Robot Middleware Supporting Self-adaptive Programming

Control Middleware for Open Robot Controllers

Comparison of real-time network traffic estimator models in gain scheduler middleware by unmanned ground vehicle network-based controller

A Novel SMMS Teleoperation Control Framework for Multiple Mobile Agents with Obstacles Avoidance by Leader Selection

On the gain scheduling for networked PI controller over IP network

Joint Mobility Control and MEC Offloading for Hybrid Satellite-Terrestrial-Network-Enabled Robots

Neural network based feedback scheduler for networked control system with flexible workload

Hybrid Event Based Control Architecture for Tele-Robotic Systems Controlled Through Internet

On network-based control and sensitivity characterization of mobile robot in intelligentspace

Performance Analysis of Universal Robot Control System Using Networked Predictive Control

Network-Based Control Adaptation For Network Qos Variation

Adaptive remote control of a mobile robot system with delay fluctuation

Implementation and Evaluation of Networked Model Predictive Control System on Universal Robot

Autonomous Internet of Things predictive control application based on wireless networked multi-agent topology and embedded operating system

The Importance, Design and Implementation of a Middleware for Networked Control Systems