Abstract:The optimal production control policy (i.e., the hedging point policy) for a single machine and single part-type manufacturing system for the case where the production surplus is accurately known has been reported in the literature. However, the production surplus is often observed inaccurately in practice. Ignoring this inaccuracy in using the optimal policy leads to not only non-robust situations but also high production costs. To consider the effect of the inaccurate observation, robustness of the production control policy is required. The robustness can be evaluated in terms of the difference between the production surplus trajectory under the policy with an inaccurate observation and the trajectory under the policy with an accurate production surplus (i.e., the hedging point policy). A difference of zero is the ideal case; however, this is generally impossible to achieve since the extent of the observation error is generally unknown. This article proposes a new robust production control policy that can give a small difference between the two trajectories. Compared with the hedging point policy, the proposed policy is more insensitive to production surplus inaccuracy in the neighborhood of the hedging point but responds more slowly to a failure of the machine. Simulation studies show that the proposed policy has a better robustness than the hedging point policy for cases where, just as in actual industrial practice, the machine failure time is much shorter than the up time of the machine. In these cases, with an increase in the observation error, the robustness of the proposed policy becomes increasingly better than that for the hedging point policy.

Optimality of Hedging Point Policies in the Production Control of Failure Prone Manufacturing Systems.

Near-Optimal Production and Maintenance Control for Failure Prone Production Systems with Demand Uncertainty

Optimal Hedging Point Control for a Failure-Prone Manufacturing System.

Optimal control of production-dependent failure-prone manufacturing systems

Structural Properties of Optimal Production Controllers in Failure-Prone Manufacturing Systems

Control Problem of Failure Prone Systems with Demand Uncertainty

Scheduling and Control of Failure Prone Systems with Demand Uncertainty and Job Overlaps

OPTIMAL CONTROL OF A CONTINUOUS-FLOW FAILURE PRONE MANUFACTURING SYSTEM

Optimal control of a failure prone manufacturing system with the possibility of temporary increase in production capacity

Production Rate Control for Failure-Prone Production Systems with No Backlog Permitted.

A simulation optimization approach in production planning of failure prone manufacturing systems

Optimal Production and Pricing Policies in a Combined Make-to-order/make-to-stock System

Robust Production Control Policy for A Single Machine and Single Part-Type Manufacturing System with Inaccurate Observation of Production Surplus

Varying Receding-Horizon Based Production Control for Hybrid Production Systems

Optimal control of failure-prone manufacturing systems

On the Ordering of Optimal Hedging Points in a Class of Manufacturing Flow Control Models

Optimization Production Control for Production System in a Defect-Prone Environment over Finite Horizon

Hierarchical optimal production control policy for production systems involving aging

Hierarichical Optimal Procuction Control Policy for Production Systems Involving Aging

The Queueing Equivalence to a Manufacturing System with Failures

Optimal Control of a Multi-State Manufacturing System: Control of Production Rate and Temporary Increase in Capacity