Abstract:Methods for locating partial defects in cables based on traveling wave reflections are typically conducted in offline states, facing numerous challenges in large cities where high reliability of power supply is required. In response to this, this paper proposes an online localization method for partial defects based on the broadband transmission coefficient spectrum at the cable end under impulse voltage. Firstly, based on transmission line theory and the distributed parameter model of the cable, a calculation formula for the transmission coefficient at the cable end is constructed, and a calculation model for the broadband transmission coefficient spectrum at the cable end containing a section with partial defects is derived. Furthermore, the generalized orthogonal integral algorithm is utilized to construct a fault diagnosis function, achieving localization of cable partial defects. Based on this, simulations were conducted on the Matlab platform to simulate the localization results of single-point and multi-point partial defects at different positions in distribution cables. Simulation results indicate that the broadband transmission coefficient spectrum at the cable end under impulse voltage can effectively locate partial aging and damage defects in distribution cables, with a relative positioning error of less than 10/0. Compared to the traveling wave reflection method, the proposed method not only enables online detection but also eliminates the need for specialized signal injection devices to connect to the cable, thereby reducing testing costs.

A novel technique for on-line location of Partial Discharges on medium voltage cables

Time-Domain Modeling and Simulation of Partial Discharge on Medium-Voltage Cables by Vector Fitting Method

On-Line Partial Discharge Localization in Power Cables Based on Electromagnetic Time Reversal Theory - Numerical Validation

A High Efficient Time-domain Modeling Method for Partial Discharge Propagation in XLPE Cables with Large Length

An Efficient Methodology of Simultaneous Three-Phase Withstand Voltage and Sensitive Partial Discharge Testing of Medium Voltage Power Cables

Simulation Of Partial Discharge Propagation Characteristics In Xlpe Cables And Joints

A Novel On-Line Differential Technique For Partial Discharge Measurement Of Mv/Hv Power Cables

Development of the Accurate Localization of Partial Discharges in Medium‐voltage XLPE Cables Based on Pulse Reconstruction

Signal Processing of On-line Partial Discharge Measurements On HV Power Cables

Partial Discharge Automatic Locating Algorithm for Cable under Oscillatory Wave Voltage Conditions Based on Traveling Wave Method

On-Line Partial Discharge Localization of 10-Kv Covered Conductor Lines

A Novel Traveling-Wave-Based Method Improved by Unsupervised Learning for Fault Location of Power Cables Via Sheath Current Monitoring.

Online Localization of Cable Partial Defects Using Broadband Transmission Coefficient Spectrum under Impulse Voltage

On-site Insulation Tests for MV Cable Using Very Low Frequency and Damped AC Techniques

Current Status of Partial Discharge Detection and Location Techniques in XLPE Power Cable

Multi-Layer Model Enabled Fault Location for Underground Cables in MMC-HVDC Grids Considering Distributed and Frequency Dependent Line Parameters

Application Of The Online Partial Discharge Monitoring For The Ehv Xlpe Cable System

A Novel Partial Discharge Locating System for 10-Kv Covered Conductor Lines in Distribution Network

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Numerical Analysis of Partial Discharge Electromagnetic Wave Propagation Characteristics in XLPE Cables and Joints

A Frequency-Domain Fault Location Method for Underground Cables in MMC-HVDC Systems