Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

A Sinusoidal Frequency Modulation Fourier Transform for Radar-Based Vehicle Vibration Estimation.

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Parameters Estimation of Sinusoidal Frequency Modulation Signal with Application in Synthetic Aperture Radar Imaging

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

A High Frequency Vibration Compensation Approach For Terahertz SAR Based on Sinusoidal Frequency Modulation Fourier Transform

Periodic-Filtering Method for Low-SNR Vibration Radar Signal

Detection Of Bio-Signals From Body Movement Based On High-Dynamic-Range Doppler Radar Sensor (Invited)

Doppler Frequency Estimation by Parameterized Time-Frequency Transform and Phase Compensation Technique

Modelling of received ultrasonic signals based on variable frequency analysis

Noncontact Distance and Amplitude-Independent Vibration Measurement Based on an Extended DACM Algorithm

Radar Fault Diagnosis Based on Wavelet Transformation and LS-SVM

High Dynamic-Range Motion Imaging Based on Linearized Doppler Radar Sensor

Time-frequency signatures of micro-doppler effect in ISAR imaging and parameter estimation

Enhanced Motion Sensing With FMCW Radar Based on a Novel Frequency-Reconfigurable Technique

OFDM Based Range and Doppler Estimation by Multivariate Frequencies

Doppler Frequency Components Estimation From Range-Doppler Spectrum Using Shipboard Coherent Microwave Radar

Ultra-micro Vibration Measurement Method Using CW Doppler Radar

Extraction of Doppler signature of micro‐to‐macro rotations/motions using continuous wave radar‐assisted measurement system

Linear-frequency-modulated Continuous-Wave Radar for Vital-Sign Monitoring

3D Microwave Vibrometer: Contactless Three-Dimensional Vibration Measurements Using Microwave Radars

Pushing the Limit of Radar-based Vibration Measurement with Deep Learning