Abstract:The IEEE 802.11 wireless local-area network (WLAN) has been deployed around the globe as a major Internet access medium due to its low cost and high flexibility and capacity. Unfortunately, dense wireless networks can suffer from poor performance due to high levels of radio interference resulting from adjoining access points (APs). To address this problem, we studied the AP transmission power optimization method, which selects the maximum or minimum power supplied to each AP so that the average signal-to-interference ratio (SIR) among the concurrently communicating APs is maximized.However, this method requires measurements of receiving signal strength (RSS) under all the possible combinations of powers. It may need intolerable loads and time as the number of APs increases. It also only considers the use of channel bonding (CB), although non-CB sometimes achieves higher performance under high levels of interference. In this paper, we present an AP interface setup optimization method using the throughput estimation model for concurrently communicating APs. The proposed method selects CB or non-CB in addition to the maximum or minimum power for each AP. This model approach avoids expensive costs of RSS measurements under a number of combinations. To estimate the RSS at an AP from another AP or a host, the model needs the distance and the obstacles between them, such as walls. Then, by calculating the estimated RSS with the model and calculating the SIR from them, the AP interface setups for a lot of APs in a large-scale wireless network can be optimized on a computer in a very short time. For evaluation, we conducted extensive experiments using Raspberry Pi for APs and Linux PCs for hosts under 12 network topologies in three buildings at Okayama University, Japan, and Jatiya Kabi Kazi Nazrul Islam University, Bangladesh. The results confirm that the proposed method selects the best AP interface setup with the highest total throughput in any topology.

Modeling AP's substitutability in dense-deployed WLANs

Modeling the Impact of the MoreData Parameter for Wireless Power-Saving Protocols

Dynamic AP Clustering and Precoding for User-Centric Virtual Cell Networks

Joint Downlink and Uplink Energy Minimization in Wet-Enabled Networks

A Location-Aware Energy Saving Mechanism for Dense Wlans

Selecting A Preferable Access Point With More Available Bandwidth

A Mathematical Model for Energy-Efficient Coverage and Detection in Wireless Sensor Networks

Discretized Optimal AP Deployment Algorithm for Indoor Environment

Energy-Efficient Clustered Cell-Free Networking with Access Point Selection

Adaptive Harvest-then-cooperate: Delay-aware Wireless Powered Communication Networks.

E-App: Adaptive Mmwave Access Point Planning with Environmental Awareness in Wireless LANs.

Distributed RIS-Enhanced Cell-Free NOMA Networks

Channel assignment based on conflict-area for reducing interference in large-scale WLANs

An Interface Setup Optimization Method Using a Throughput Estimation Model for Concurrently Communicating Access Points in a Wireless Local Area Network

Energy-Efficient WLANs with Resource and Re-Association Scheduling Optimization

Improved AP Deployment Optimization Scheme Based on Multi-objective Particle Swarm Optimization Algorithm.

Novel Access Point Deployment Method in WIFI Convergence Network

Network Association Strategies for an Energy Harvesting Aided Super-WiFi Network Relying on Measured Solar Activity

Placement Optimization of Energy and Information Access Points in Wireless Powered Communication Networks

Cell Breathing Based on Supply-Demand Model in Overlapping WLAN Cells

Toward the Energy-Saving Optimization of WLAN Deployment in Real 3-D Environment: A Hybrid Swarm Intelligent Method