Abstract:The green wave coordinated control model has evolved from the basic bandwidth maximization model to the multiweight approach to an asymmetrical multiband model and a general signal progression model with phase optimization to improve the operational efficiency of urban arterial roads and reduce driving delays and the amount of exhaust gas generated by vehicles queuing at intersections. However, most of the existing green wave models of arterial roads are based on a single phase pattern and little consider the optimization of the combination of multiple phase patterns. Initial queue clearing time is also considered at the green wave progression line in the time–space diagram, which leads to a waste of green light time. This study proposes a coordination control optimization method based on an asymmetrical multiband model with phase optimization to address the abovementioned problem. This model optimizes four aspects in the time–distance diagram: phase pattern selection, phase sequence, offset, and queue clearing time. Numerical experiments were conducted using the VISSIM micro traffic simulation tool for intersections along Kunlunshan South Road in Qingdao, and the effect of green wave coordination was evaluated using hierarchical analysis and compared with the signal-timing schemes generated by the four models: the multiweight approach, the improved multiweight approach, an asymmetrical multiband model, and a general signal progression model with phase optimization. The results show that an asymmetrical multiband model with phase optimization obtains a total bandwidth of 314 s in both directions. In the outbound direction, average number of stops, average travel speed, average travel time, and average delay time improve by 16%, 7.9%, 17.9%, and 15.6%, respectively. In the inbound direction, they improve by 43.7%, 16.1%, 40.7%, and 36%, respectively. Polluting gas emissions and fuel consumption improve by 17.9%. The applicability of the optimization method under different traffic flow conditions is analyzed, and results indicate a clear control effect when the traffic volume is moderate and the turning vehicles on the feeder roads are few. This work can provide a reference for the optimization of subsequent arterial signal coordination and also has indirect significance for environmental protection to a certain extent.

Coordinated Control of Traffic Flow in Complex-Arterial Networks under the Big Data Background

A Green Wave Band Based Method for Urban Arterial Signal Control

A Two-Way Arterial Signal Coordination Method with Queueing Process Considered

Based on Simulation Method for Solving Traffic Jam Problems.

A Max Pressure Approach to Urban Network Signal Control with Queue Estimation Using Connected Vehicle Data

Joint Queue Estimation and Max Pressure Control for Signalized Urban Networks with Connected Vehicles

A Signal Coordination Model for Long Arterials Considering Link Traffic Flow Characteristics

A Decentralized Model Predictive Traffic Signal Control Method with Fixed Phase Sequence for Urban Networks.

Signal Coordination Models for Long Arterials and Grid Networks

Traffic Scheduling and Control in Fully Connected and Automated Networks

Research on signal control methods of traffic bottlenecks in city road network

A Traffic Flow Model and Intelligent Control Technique for Urban Trunk Road

Actuated green wave control for grid-like network traffic signal coordination

Traffic Signal Control Model Based on Queue Management in High-Density Network

Research on Red Wave and Green Wave Coordinated Control Model in Arterial Road for Different Traffic Demands

A congestion eliminating control method for large-scale urban traffic networks

Coping with Large Traffic Volumes in Schedule-Driven Traffic Signal Control

Data-Driven Model For Traffic Signal Control

Arterial Coordination Control Optimization Based on AM–BAND–PBAND Model

Coordinated Control Model for Arterials with Asymmetric Traffic