Abstract:Surface discharge in a vacuum occurs under an intense external field, also called a flashover. The flashover threshold over which the surface flashover occurs is of vital importance in the vacuum-solid interface. It is widely assumed that the flashover is initiated by a single surface multipactor and develops as a plasma discharge along a dielectric surface, namely the secondary electron emission avalanche (SEEA). Yet the SEEA model is not versatile for all practical vacuum-solid interfaces and there remain experiment results contradicting the theory predictions without a resolute answer. Here we further expand on previous theories and consider the conventional SEEA model under arbitrary field distributions. The example of a conical insulator is then given to test the validity of the SEEA model under an arbitrary field. It is found that the obtained flashover threshold is only consistent with the experiment at low cone angles where the field near the cathode triple junction is strong, while remarkable discrepancies appear when the anode field is significantly enhanced. The discrepancies can be understood if a different discharge model, i.e. an anode-initiated flashover (AIF) is included. Both particle-in-cell simulation and optical diagnostics are employed to visualize this unique discharge, which are then formalized on theoretical grounds to elucidate the early stage of the AIF. The transition between two flashover phases is then clarified. The plasma-surface interaction and sheath dynamics during the discharge are analyzed theoretically, showing distinct sheath evolutions in two flashover models. Additionally, a new factor reflecting field distortion is introduced to estimate the discharge threshold under an SEEA framework.

Evolution from Cathode-Initiated to Anode-Initiated Flashover in Vacuum

Influence of Flashover Initiation Process on Surface Insulation Performance for Insulators under Impulse Voltage in Vacuum

Simulation research on the development of vacuum flashover through outgassing and discharge

Surface and Interface Physical Phenomena Induced by Flashover Across Solid Dielectrics in Vacuum

Monte Carlo Simulation of Temporal Behavior of Surface Charging Across Insulator at Flashover Initial Stage in Vacuum

Evolution of vacuum surface flashover for angled dielectric insulators with particle-in-cell simulation

Simulation on the Dynamic Charge Behavior of Vacuum Flashover Developing Across Insulator Involving Outgassing

Estimation of Surface Flashover Threshold in a Vacuum II: Flashover Phase Transition

Luminescence Evolution from Alumina Ceramic Surface Before Flashover under Direct and Alternating Current Voltage in Vacuum

2D particle-in-cell simulation of the entire process of surface flashover on insulator in vacuum

Self-Consistent Simulation of the Initiation of the Flashover Discharge on Vacuum Insulator Surface

Investigation on Developing Process of Impulse Flashover Across Alumina Ceramic with Asymmetric Electrodes in Vacuum

Two Modes of Vacuum Flashover Process under Pulsed Voltage

Pulsed Flashover Developing Across Alumina Ceramic in Vacuum

Monte-carlo simulation on improving flashover voltage through electromagnetic methods

Modelling the Effect of Charge Transport on Surface Flashover in Vacuum

Estimation time delay from field emission to secondary electron emission avalanche in vacuum surface flashover

Process of Surface Flashover in Vacuum Under Nanosecond Pulse

Simulation Research on Surface Charging Phenomena Across Solid Dielectrics Prior to Flashover in Vacuum

Optical Investigation of Surface Flashover Plasma Across Silicon Stimulated by Pulsed High Voltage in Vacuum Based on Iccd

Monte Carlo Simulation of Surface-Charging Phenomena on Insulators Prior to Flashover in Vacuum