Abstract:Maximum baud rate of electrical signaling over backplanes is limited by reflection and crosstalk noise at connectors as well as ISI caused by frequency-dependent dielectric loss. A DFE is an effective circuit to alleviate ISI without amplifying noise. A multi-tap DFE is often used in order to cancel long-tail ISI [1–3]. However, multiple DFE taps may limit maximum operation speed due to analog feedback when using non-speculative taps [1,2], or increase power and area exponentially when using multiple speculative taps [3]. Another approach is a combination of a 1-tap speculative DFE to get faster speed and a linear equalizer (LE) to cancel the long-tail ISI [4,5]. Adaptive control is challenging when combining LE and DFE, because the relationship between LE and DFE must be taken into account [5], and the sign-sign-least-mean-square (SS-LMS) algorithm [7] that is commonly used in DFEs is not applicable to some types of LE, or at the cost of increased power and area for parallel signal paths in LE [6]. The zero-forcing (ZF) algorithm for analog filters [8] is applicable to any type of LE, but it needs an ADC and a large amount of logic to perform matrix multiplication. A heuristic algorithm [5] requires an eye measurement circuit, microcontroller, and control software.

A 10gb/s Speculative Decision Feedback Equalizer with a Novel Implementation of Adaption in 65nm CMOS Technology

A 25gb/s Adaptive Decision Feedback Equalizer for 100G Ethernet in 65NM CMOS Technology

10 Gbit/s Serial Link Receiver with Speculative Decision Feedback Equaliser Using Mixed-Signal Adaption in 65 Nm CMOS Technology

A 10-Gb/s simplified transceiver with a quarter-rate 4-tap decision feedback equalizer in 0.18-μm CMOS technology

A 40Gb/s 39mW 3-tap adaptive closed-loop decision feedback equalizer in 65nm CMOS

A 6.25-Gbps 4-Tap Low-Power Decision Feedback Equalizer in 0.13µm CMOS Technology

A 9-Gb/s Quarter-Rate 4-Tap Decision Feedback Equalizer in 0.18-Μm CMOS Technology

A 40gb/s 27mw 3-Tap Closed-Loop Decision Feedback Equalizer in 65nm CMOS.

40 Gbps 4‐level Pulse Amplitude Modulation Closed‐loop Decision‐feedback Equaliser with High‐speed Comparator in 55 Nm CMOS Technology

An Adaptive DFE Using Pattern-Dependent Data-Level Reference in 28 Nm CMOS Technology

A 3.75gbps Configurable Continuous Time Linear Equalizer and 3-Tap Decision Feedback Equalizer in 65nm Cmos

A 10-Gb/s 5-Tap DFE/4-Tap FFE Transceiver in 90-Nm CMOS Technology

A 56 Gbps 4‐tap PAM‐4 Direct Decision Feedback Equaliser with Negative Capacitance Employing Dynamic CML Comparators in 65‐nm CMOS

A 0.002-mm 6.4-mW 10-Gb/s Full-Rate Direct DFE Receiver With 59.6% Horizontal Eye Opening Under 23.3-dB Channel Loss at Nyquist Frequency

A 40gb/s Adaptive Equalizer with Amplitude Approaching Technique in 65nm Cmos

A 4-Channel 10.3gb/s Backplane Transceiver Macro with 35db Equalizer and Sign-Based Zero-Forcing Adaptive Control

ASIC Design Optimization of a Decision Feedback Equalizer at Single-Carrier Ultra-Wide Band

A 4-Channel 1.25–10.3 Gb/s Backplane Transceiver Macro with 35 Db Equalizer and Sign-Based Zero-Forcing Adaptive Control

A 48mw 15-to-28gb/s Source-Synchronous Receiver with Adaptive DFE Using Hybrid Alternate Clock Scheme and Baud-Rate CDR in 65nm CMOS.

Co-design of 40Gb/s equalizers for wireline transceiver in 65nm CMOS technology

6.3 A 0.43pJ/b 200Gb/s 5-Tap Delay-Line-Based Receiver FFE with Low-Frequency Equalization in 28nm CMOS