Abstract:Phase sensitive optical time domain reflectometry (Φ-OTDR) has been widely used in many applications for its distributed sensing ability on weak disturbance all along the sensing fiber. However, traditional Φ-OTDR cannot make quantitative measurement on the external disturbance due to the randomly distributed position and reflectivity of scatters within the optical fiber. Recently, some methods have been proposed to realize quantitative measurement of dynamic strain. In these literatures, the fiber with or without FBGs in practice was easily damaged and with difficulty of maintenance. PZT is employed to generate strain event in the fiber. There is a large gap compared with the real detecting environment, which will not reveal the full performance of the sensing system. In this paper, a distributed optical fiber sensing (DOFS) system for dynamic strain measurement based on artificial reflector is proposed and demonstrated experimentally. The fiber under test (FUT) is composed by four 20-meter long single mode optical fiber patch cords (OFPCs), which are cascaded with ferrule contactor/physical contact (FC/PC) connectors via fiber flanges. The fiber facet of FC/PC connector forms an artificial reflector. When the interval between the two reflectors is changed, the phase of the interference signal will also be changed. A symmetric 3×3 coupler with table-look-up scheme is introduced to discriminate the phase change through interference intensity. In our experiment, the center 10m section of the second OFPC is attached to the bottom of an aluminum alloy plate. An ordinary loudspeaker box was located on the top of the aluminum alloy plate. The dynamic strain generated by the loudspeaker box is transmitted from the aluminum alloy plate to the OFPC. Experimental results show that the proposed method has a good frequency response characteristic up to 3.2 kHz and a linear intensity response of R2=0.9986 while the optical probe pulse width and repetition rate were 100ns and 10 kHz respectively. Meanwhile, triangle and cosine amplitude-modulated (AM) dynamic strain applied on the fiber are successfully discriminated. The artificial reflectors based on FC/PCs were easily assembled and maintained, and the method of vibration transmission closely resembled the real circumstance than PZT. Therefore, these advantages will extend the potential of this Φ-OTDR technology in structure health monitoring.

Strain Variation Measurement with Short-Time Fourier Transform-Based Brillouin Optical Time-Domain Reflectometry Sensing System

Brillouin optical time domain reflectometry for fast detection of dynamic strain incorporating double-edge technique

Distributed optical fiber sensing based on the combination of Brillouin and Rayleigh scattering

Improvement of spatial resolution of Brillouin optical time domain reflectometer using spectral decomposition

A High Performance Distributed Optical Fiber Sensor Based on Φ-OTDR for Dynamic Strain Measurement

Stain monitoring for tunnel using distributed optical fiber BOTDR sensors

Improved Φ-OTDR Sensing System for High-Precision Dynamic Strain Measurement Based on Ultra-Weak Fiber Bragg Grating Array

A Distributed Optical Fiber Sensing System for Dynamic Strain Measurement Based on Artificial Reflector

A Wavelength-Scanning Brillouin Optical Time Domain Reflectometer

Hybrid B-OTDR/Φ-OTDR for Multi-Parameter Measurement from a Single End of Fiber

High-speed Quasi-Distributed Strain Sensing Based on Time Division Multiplexing of Fibre Bragg Gratings

STUDY ON BOTDR-BASED DISTRIBUTED OPTICAL FIBER STRAIN MEASUREMENT FOR TUNNEL HEALTH DIAGNOSIS

The study on prestressed cable stress based on Brillouin-optictime optic fiber sensor

Proposal of Brillouin Optical Time Domain Collider for Dynamic Strain Measurement

Long-distance OFDR with High Spatial Resolution based on Time Division Multiplexing

Multi-point Dynamic Strain Sensing using External Phase Modulation-based Brillouin Optical Correlation Domain Analysis

Determination of thermal residual strain in cabled optical fiber with high spatial resolution by Brillouin optical time-domain reflectometry

High-Precision Measurement of Brillouin Frequency Shift in Brillouin Optical Time-Domain Reflectometer Based on Half-Peak Fitting Algorithm of Power Spectrum

Distributed Fiber Strain and Vibration Sensor Based on Brillouin Optical Time-Domain Reflectometry and Polarization Optical Time-Domain Reflectometry.

A New Distributed Optical Fiber Sensor For Structural Health Monitoring - Botdr

Strain-induced Vibration and Temperature Sensing BOTDA System Combined Frequency Sweeping and Slope-Assisted Techniques