Abstract:At present, most of the existing research on low-speed permanent magnet motors (LSPMMs) focuses on the surface-mounted type. There are few other rotor structures, and there is no comprehensive comparison of several widely used rotor structures. A comprehensive comparison of three different rotor structures for low-speed mining motors is carried out, including electromagnetic and loss characteristics, permanent magnet consumption, temperature distribution, etc. Firstly, three rotor structures of a 500 kW, 60 rpm low-speed motor are introduced, and the initial design parameters are determined. Secondly, the influence of each rotor design parameter on the electromagnetic characteristics is analyzed. Next, the electromagnetic optimization of the three rotor structures is carried out, and the motor performance of the three rotor structure optimization schemes is compared, including electromagnetic performance, permanent magnet consumption, motor temperature distribution, etc. Finally, in order to verify the correctness of the theoretical analysis, a prototype is made and tested based on the above analysis. The results show that for the electromagnetic characteristics, when the motors with three different rotor structures meet the performance requirements, the no-load line back-EMF of the inset surface-mounted motor is the lowest, but the back-EMF harmonic content of the inset surface-mounted motor is the highest. The copper loss of the spoke-type motor is the smallest, the efficiency is the highest, and the power factor is the lowest. In addition, the surface-mounted motor has the least consumption of permanent magnets and is more economical. Regarding the temperature distribution, when the same heat dissipation system is used, the temperature of the spoke-type motor with minimum copper loss is the lowest.

Comparative study on structure of laminated-rotor high-speed induction machine

Comparison of Optimal Design and Performance of PM Machines Having Non-Overlapping Windings and Different Rotor Topologies

Comparative Investigation Of Single-Sided And Double-Sided Permanent Magnet Linear Motor

Rotor Strength Analysis for High Speed Permanent Magnet Machines

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

Performance Study and Optimization Design of High-Speed Amorphous Alloy Induction Motor

Comparative Study of Novel Doubly-Fed Linear Switched Flux Permanent Magnet Machines with Different Primary Structures

Strength Analysis for Surface-mounted Permanent Magnet Rotor in High-Speed Motor

Optimization Design of Linear Induction Motor and Study of the 3-Phase Asymmetry Phenomenon

Design Optimization with Outer Rotor Interior Permanent Magnet Synchronous Motor with Hybird Permanent Magnet

Research on Rotor Structure Safety of High-speed Permanent Magnet Motor

Rotor Strength Analysis of High-speed Permanent Magnet Synchronous Motors

Comparative Analysis of Doubly Fed Flux-Reversal Permanent Magnet Machines with Different PM Arrangements and Consequent-Pole Topologies

Performance Entitlement by Using Novel High Strength Electrical Steels and Copper Alloys for High-Speed Laminated Rotor Induction Machines

Comprehensive Comparison of Different Rotor Structures of Low-Speed Permanent Magnet Motor

Comparative Study of 6-Slot/2-pole High-Speed Permanent Magnet Motors with Different Winding Configurations

Multiphysics Comparative Study of High Speed PM Machines for Ring PM Rotor and Solid PM Rotor

Analysis of Loss and Temperature of a High Speed Motor with Composite Magnetic Fiber Rotor

Evaluation of Applying Retaining Shield Rotor for High-Speed Interior Permanent Magnet Motors

Analysis of the Rotor Mechanical Strength of Interior Permanent Magnet Synchronous In-Wheel Motor with High Speed and Large Torque