Abstract:This paper presents the analysis and design of a novel traction control system (TCS) based on sliding-mode control (SMC) and maximum transmissible torque estimation (MTTE) technique, which is employed in four-wheel independent drive electric vehicles (EVs) without detecting the vehicle velocity and acceleration. The original MTTE technique is effective with regard to the antislip control; however, it cannot sufficiently utilize the adhesive force from the tire–road surface. In the proposed TCS algorithm, only front wheels are equipped with the MTTE technique, while rear wheels are equipped with the SMC technique. As a result, the front wheel is critically controlled by the MTTE technique. Thus, its rotary speed can be used to approximately estimate the chassis velocity and acceleration, which are key input parameters of the SMC. The rear wheel slip ratio can be therefore controlled by the SMC which is robust against uncertainties and disturbances of parameters for exploiting more transmissible friction force. In addition, the stability of MTTE is analyzed in this paper because an important parameter is neglected in the original MTTE technique. As a result, the stability condition is changed, and the MTTE is modified in the proposed TCS according to the new conclusion. A half four-wheel drive (4WD) EV model is initially built using matlab/simulink. This paper investigates the proposed TCS for various adhesive conditions involving abrupt change in road friction. Compared with the original MTTE technique, the comprehensive performance, particularly the acceleration ability, is significantly improved by the proposed controller. The simulation result validates the effectiveness and robustness of the proposed TCS.

The Design of TCS Controller for Four Wheel Independent-Drive Electric Vehicle Based on ADRC

Study on Differential Assist Steering System with Double In-Wheel Motors with Intelligent Controller

Four-Wheel Independent Drive Electric Vehicle Stability Control Using Novel Adaptive Sliding Mode Control

Design of Torque Distribution Strategy for Four-Wheel-Independent-Drive Electric Vehicle

Lateral Stability Control of Four-Wheel-Drive Electric Vehicle Based on Coordinated Control of Torque Distribution and ESP Differential Braking

Robust path following control of 4WID autonomous vehicle with driving condition adaptive mechanism

Practical active traction control for independent‐wheel‐drive electric vehicle based on slip‐ratio threshold determination

Research on Anti-Skid Control Strategy for Four-Wheel Independent Drive Electric Vehicle

Trajectory tracking control for four-wheel independent drive intelligent vehicle based on model predictive control and sliding mode control

Wheel Slip Control Using Sliding-Mode Technique and Maximum Transmissible Torque Estimation

Coaxial-coupling Traction Control for a Four-Wheel-independent-drive Electric Vehicle on a Complex Road

Trajectory Tracking Control for Four-Wheel Independently Driven Electric Vehicle Based on Model Predictive Control and Sliding Model Control

Nonlinear hierarchical control for four-wheel-independent-drive electric vehicle

Path tracking control of 4-wheel-steering autonomous ground vehicles based on linear parameter-varying system with experimental verification

Design of slip-based traction control system for EV and validation using co-simulation between Adams and Matlab/Simulink

Lateral Stability Analysis of 4WID Electric Vehicle Based on Sliding Mode Control and Optimal Distribution Torque Strategy

Adaptive sliding mode control for 4-wheel SBW system with Ackerman geometry

Extension coordinated control of four wheel independent drive electric vehicles by AFS and DYC

Coordinated Traction Control of Intelligent Four-Wheel-drive Vehicles under Complex Start Up Situation.

Development and evaluation of torque distribution methods for four-wheel independent-drive electric vehicle based on parameter estimation

Coordinated Control for the Trajectory Tracking of Four-Wheel Independent Drive–Four-Wheel Independent Steering Electric Vehicles Based on the Extension Dynamic Stability Domain