Abstract:The development of perpetually powered sensor networks for environment monitoring to avoid periodic battery replacement and to ensure the network never goes offline due to power is one of the primary goals in sensor network design. In many environment-monitoring applications, the sensor network is internet-connected, making the energy budget high because data must be transmitted regularly to a server through an uplink device. Determining the optimal solar panel size that will deliver sufficient energy to the sensor network in a given period is therefore of primary importance. The traditional technique of sizing solar photovoltaic (PV) panels is based on balancing the solar panel power rating and expected hours of radiation in a given area with the load wattage and hours of use. However, factors like the azimuth and tilt angles of alignment, operating temperature, dust accumulation, intermittent sunshine and seasonal effects influencing the duration of maximum radiation in a day all reduce the expected power output and cause this technique to greatly underestimate the required solar panel size. The majority of these factors are outside the scope of human control and must be therefore be budgeted for using an error factor. Determining of the magnitude of the error factor to use is crucial to prevent not only undersizing the panel, but also to prevent oversizing which will increase the cost of operationalizing the sensor network. But modeling error factors when there are many parameters to consider is not trivial. Equally importantly, the concept of microclimate may cause any two nodes of similar specifications to have very different power performance when located in the same climatological zone. There is then a need to change the solar panel sizing philosophy for these systems. This paper proposed the use of actual observed solar radiation and battery state of charge data in a realistic WSN-based automatic weather station in an outdoor uncontrolled environment. We then develop two mathematical models that can be used to determine the required minimum solar PV wattage that will ensure that the battery stays above a given threshold given the weather patterns of the area. The predicted and observed battery state of charge values have correlations of 0.844 and 0.935 and exhibit Root Mean Square Errors of 9.2% and 1.7% for the discrete calculus model and the transfer function estimation (TFE) model respectively. The results show that the models perform very well in state of charge prediction and subsequent determination of ideal solar panel rating for sensor networks used in environment monitoring applications.

Indoor environment PV applications: Estimation of the maximum harvestable power

Evaluation of Solar Radiation Models on Vertical Surface for Building Photovoltaic Applications in Beijing

Practical PV energy harvesting under real indoor lighting conditions

Optimization of Photovoltaic Power Plant Design Scheme Based on Power Generation Model

Low-Cost Sensors for Indoor PV Energy Harvesting Estimation Based on Machine Learning

New Techniques for Sizing Solar Photovoltaic Panels for Environment Monitoring Sensor Nodes

Indoor light energy harvesting for battery-powered sensors using small photovoltaic modules

Performance Assessment of Mismatch Mitigation Methodologies Using Field Data in Solar Photovoltaic Systems

Enhancing Power Prediction of Photovoltaic Systems: Leveraging Dynamic Physical Model for Irradiance-to-Power Conversion

Photovoltaic Model-Based Solar Irradiance Estimators: Performance Comparison and Application to Maximum Power Forecasting

Evaluation of energy extraction of PV systems affected by environmental factors under real outdoor conditions

Evaluating Outdoor Performance of PV Modules Using an Innovative Explicit One-Diode Model

Modelling and Analysis of High Performance for Solar Power Injection with Distribution Networks

Investigation of Self-Powered IoT Sensor Nodes for Harvesting Hybrid Indoor Ambient Light and Heat Energy

Real‐time estimation of solar irradiance and module temperature from maximum power point condition

IoT‐based low‐cost prototype for online monitoring of maximum output power of domestic photovoltaic systems

The impact of spectral distribution on photovoltaic power generation and its quantitative evaluation model

Estimation of Solar Radiation on a PV Panel Surface with an Optimal Tilt Angle Using Electric Charged Particles Optimization

A new approach to estimate the performance and energy productivity of photovoltaic modules in real operating conditions

Parameter Estimation and Preliminary Fault Diagnosis for Photovoltaic Modules Using a Three-Diode Model

Advanced PV Performance Modelling Based on Different Levels of Irradiance Data Accuracy