Abstract:The primary objective of this study is to investigate the potential of using microscopic simulation models and Surrogate Safety Assessment Model (SSAM) for evaluating the safety performance of signalized intersections. A widely used microscopic simulation package VISSIM was used in this study to develop simulation models. The validity of using VISSIM and SSAM for traffic safety analysis at signalized intersections was tested by comparing the simulated conflicts to those measured in the field using traditional traffic conflicts techniques. Of particular interest was to identify if the consistency between simulated and observed conflicts could be improved by calibrating VISSIM simulation models and adjusting threshold values used for defining simulated conflicts in SSAM. A two-stage procedure was proposed in this study to develop, calibrate and validate VISSIM simulation models. It was found that the two-stage calibration procedure greatly improved the goodness-of-fit between simulated conflicts and real-world conflicts. After model calibration, the mean absolute percent error (MAPE) for total conflicts was reduced from 44% to 24%. More specifically, the MAPE value was reduced from 26% to 15% for rear-end conflicts, from 69% to 29% for crossing conflicts, and from 83% to 81% for lane-change conflicts. Linear regression models and the spearman rank correlation coefficient were also developed to study the relationship between simulated conflicts and observed conflicts. Data analysis results showed that there was a reasonable goodness-of-fit between simulated and observed rear-end and crossing conflicts. However, it was also found that the simulated conflicts generated by VISSIM and SSAM are not good indicators for traffic conflicts which are generated by unexpected driving maneuvers such as illegal lane-changes in the real world.

Study on FLOWSIM and its Application for Isolated Signalized Intersection Assessment

Study on FLOWSIM and its Application for Isolated Signal-ized Intersection Assessment

Q-learning Based Traffic Signal Control Method for an Isolated Intersection

Study on Application of FLOWSIM Micro-Simulation System for Urban Traffic

Traffic Signal Control Optimization Strategy Based on Simulation

Application of fuzzy control theory in multi-phase traffic control of single intersection

FLOWSIM and Its Applications for Convoy Driving System Stability Study

Application Of Fuzzy Control Theory In Multi Phase Traffic Control Of Single Intersection

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Traffic flow model by simulating circuit at signalized intersections

Modeling lane changing behavior using fuzzy logic

Study on transfer functions model of urban traffic flow at intersection

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections

Fuzzy Neural Network Control Technique and Its Application in A Complex Intersection

A Fuzzy Logic Microscopic Simulation Model for Interurban Att Assessment

Design of On-line Simulation System for Signal Control of Urban Intersections Based on Visual Sensing Technology

Learning Based Fuzzy Control Strategy Design for a Signalized Intersection

Simulation of Departure Flow Profile at Stop Lines for Signal Approach Spillover

Comparative study on simulation performances of CORSIM and VISSIM for urban street network.

Evaluation and Simulation Study of Traffic at Intersection of Wuhan Heping Avenue-Jianshe No.2 Road

Based on Simulation Method for Solving Traffic Jam Problems.