Abstract:The IEEE 802.11 wireless local-area network (WLAN) has been deployed around the globe as a major Internet access medium due to its low cost and high flexibility and capacity. Unfortunately, dense wireless networks can suffer from poor performance due to high levels of radio interference resulting from adjoining access points (APs). To address this problem, we studied the AP transmission power optimization method, which selects the maximum or minimum power supplied to each AP so that the average signal-to-interference ratio (SIR) among the concurrently communicating APs is maximized.However, this method requires measurements of receiving signal strength (RSS) under all the possible combinations of powers. It may need intolerable loads and time as the number of APs increases. It also only considers the use of channel bonding (CB), although non-CB sometimes achieves higher performance under high levels of interference. In this paper, we present an AP interface setup optimization method using the throughput estimation model for concurrently communicating APs. The proposed method selects CB or non-CB in addition to the maximum or minimum power for each AP. This model approach avoids expensive costs of RSS measurements under a number of combinations. To estimate the RSS at an AP from another AP or a host, the model needs the distance and the obstacles between them, such as walls. Then, by calculating the estimated RSS with the model and calculating the SIR from them, the AP interface setups for a lot of APs in a large-scale wireless network can be optimized on a computer in a very short time. For evaluation, we conducted extensive experiments using Raspberry Pi for APs and Linux PCs for hosts under 12 network topologies in three buildings at Okayama University, Japan, and Jatiya Kabi Kazi Nazrul Islam University, Bangladesh. The results confirm that the proposed method selects the best AP interface setup with the highest total throughput in any topology.

Temporary Access Selection Technology in WIFI Networks.

A User-Preference-Aware Terminal-Controlled Access Network Selection Scheme in Heterogeneous Wireless Networks.

Optimization for the Deployment and Transmitting Power of AP Based on Green WLAN

Novel Access Point Deployment Method in WIFI Convergence Network

Selecting A Preferable Access Point With More Available Bandwidth

SmartAssoc: Decentralized Access Point Selection Algorithm to Improve Throughput

GreenAP: an Energy-Saving Protocol for Mobile Access Points

Joint Downlink and Uplink Energy Minimization in Wet-Enabled Networks

Green Wi-Fi Implementation and Management in Dense Autonomous Environments for Smart Cities.

Designing a Practical Access Point Association Protocol

Green AP Dynamic and Adaptive Control Algorithm

An Interface Setup Optimization Method Using a Throughput Estimation Model for Concurrently Communicating Access Points in a Wireless Local Area Network

Energy-saving access point configurations in WLANs: a swarm intelligent approach

Access Points Selection In Super Wifi Network Powered By Solar Energy Harvesting

Energy-Efficient WLANs with Resource and Re-Association Scheduling Optimization

SES: Stable and Efficient Solution for Rate Control and Spectrum Allocation in Wireless LANs

Integrated Access Selection Considering Wired and Wireless Resources

Traffic Prediction Enabled Dynamic Access Points Switching for Energy Saving in Dense Networks.

A Primer on AP Power Save in Wi-Fi 8: Overview, Analysis, and Open Challenges

Buffer-Aided Adaptive Wireless Powered Communication Network with Finite Energy Storage and Data Buffer

Energy Efficiency Driven Random Access in WLAN System.