Abstract:CMOS imagers are becoming increasingly popular in astronomy. A very low noise level is required to observe extremely faint targets and to get high-precision flux measurements. Although CMOS technology offers many advantages over CCDs, a major bottleneck is still the read noise. To move from an industrial CMOS sensor to one suitable for scientific applications, an improved design that optimizes the noise level is essential. Here, we study the 1/f and thermal noise performance of the source follower (SF) of a CMOS pixel in detail. We identify the relevant design parameters, and analytically study their impact on the noise level using the BSIM3v3 noise model with an enhanced model of gate capacitance. Our detailed analysis shows that the dependence of the 1/f noise on the geometrical size of the source follower is not limited to minimum channel length, compared to the classical approach to achieve the minimum 1/f noise. We derive the optimal gate dimensions (the width and the length) of the source follower that minimize the 1/f noise, and validate our results using numerical simulations. By considering the thermal noise or white noise along with 1/f noise, the total input noise of the source follower depends on the capacitor ratio CG/CFD and the drain current (Id). Here, CG is the total gate capacitance of the source follower and CFD is the total floating diffusion capacitor at the input of the source follower. We demonstrate that the optimum gate capacitance (CG) depends on the chosen bias current but ranges from CFD/3 to CFD to achieve the minimum total noise of the source follower. Numerical calculation and circuit simulation with 180nm CMOS technology are performed to validate our results.

Analysis and Design of Low-Distortion CMOS Source Followers

An Analysis and Implementation of Common Mode Feedback in High-Speed Fully Differential Op-Amp

Analysis and Design of High Power Supply Rejection LDO

Physical design optimization of MOSFETs for millimeter wave and sub-millimeter wave circuits

Improving Source-Follower Buffer For High-Speed Adc Testing

Miller Effect Analysis and Noise Optimization of CMOS Low Noise Amplifier

Noise optimization of the source follower of a CMOS pixel using BSIM3 noise model

Modeling and Optimization of Substrate Electromagnetic Coupling and Isolation in Modern Lightly Doped CMOS Substrate

A Wideband Input Buffer Based on Cascade Complementary Source Follower

Notice of Retraction: A Novel Coplanar Common-Mode Filter with a Wide Stopband

A CMOS High-Speed Multistage Preamplifier for Comparator Design

An Impedance Adapting Compensation Scheme for High Current NMOS LDO Design

A MATLAB program for Volterra distortion analysis in CMOS switched source follower

Analysis on Static Current Sharing of N-Paralleled Silicon Carbide MOSFETs

Circuit Design and Verification of On-Chip Femto-Ampere Current Mode Circuit Using 0.18μm CMOS Technology

Design of a compact MOSFET model suitable for geometric programming

The Design Of Cmos Rf Low Noise Amplifiers

A 77-dB-DR 0.65-mW 20-MHz 5th-Order Coupled Source Followers Based Low-Pass Filter

Design of CMOS sine-wave oscillator with low output harmonic distortion

Low-Noise, High-Linearity Sine-Wave Generation Using Noise-Shaping Phase-Switching Technique

Approaches and Options for Modeling Sub-0.1 /spl Mu/m CMOS Devices