Abstract:Due to the development of microprocessor technology, there are more than 20 billion sensor-based devices connected to the Internet of Things (IoT) to monitor physical phenomena and events. To reduce the energy used by idle listening, a low-duty cycle is often used in an event-sparse wireless sensor network. However, low-duty cycles bring large end-to-end delays. In this paper, a listen interval adaptive adjustment (LIAA) scheme is proposed to adjust the listen interval (LI) of a node to reduce end-to-end delays while maintaining the long lifetime of a network. The key idea is to make full use of the energy consumption imbalance in a network, to allow nodes away from the sink to use the residual energy to add listen intervals. The LIAA scheme has 3 sub-strategies. One is the basic add listen interval (BALI) strategy, in which the parent node adds listen intervals in the fixed active slots of its child nodes. Another strategy is the consecutive listen (CL) scheme, which is based on BALI, and listen intervals are added consecutively. The third strategy is the random add listen interval (RALI) scheme, which uses the idea of randomness to add listen intervals. The extensive theoretical analysis and experimental results show that the LIAA scheme proposed in this paper has better performance. Compared with the traditional scheme, the delays in the BALI scheme, CL scheme and RALI scheme were reduced by 24.03%, 23.45% and 39.41%, respectively, while the lifetime of the network was maintained.

Energy-efficient Idle Listening Scheme Using 1 Bit Sampling in 60 GHz Wireless Local Area Network

Energy-Efficient 1-Bit-Sampling Idle Listening Scheme for 60-GHz WLAN Systems

Energy-Efficient Scheme For Ieee 802.15.4 Compliant Device

A 40-Mw 7-Bit 2.2-Gs/s Time-Interleaved Subranging ADC for Low-Power Gigabit Wireless Communications in 65-Nm CMOS

A 40-mW 7-bit 2.2-GS/s Time-Interleaved Subranging CMOS ADC for Low-Power Gigabit Wireless Communications.

A 14-Bit 500-Ms/S Sha-Less Pipelined Adc In 65nm Cmos Technology For Wireless Receiver

Energy Efficiency Optimization for Millimeter Wave System with Resolution-Adaptive ADCs

Signaling with Imperfect Channel State Information: A Battery Power Efficiency Comparison

Signal Power Estimation of All Sensor Network Nodes with Measurements from a Subset of Network Nodes

Cutting Down Idle Listening Time: A NDN-Enabled Power Saving Mode Design for WLAN.

A MAC Protocol with Little Idle Listening for Wireless Sensor Networks

A Flexible Back-End with Optimum Threshold Estimation for OOK Based Energy Detection IR-UWB Receivers

A Low-Power and Flexible Energy Detection IR-UWB Receiver for RFID and Wireless Sensor Networks

Massive MIMO-ISAC System With 1-Bit ADCs/DACs

One-Bit Spectrum Sensing for Cognitive Radio

LIAA: A listen interval adaptive adjustment scheme for green communication in event-sparse IoT systems

IPS-MAC: an Informative Preamble Sampling MAC Protocol for Wireless Sensor Networks

Power-Aware Optimization for Cs-Based Ir-Uwb System

A 2.4 GHz 2.9 Mw Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

A Low Power 1G-Samples/s, 6-Bit Folded Interpolation ADC Integrated Circuit Design

Adaptive Synchronization and Integration Region Optimization for Energy Detection IR-UWB Receivers.