Abstract:Mapping trace gas emission plumes using in situ measurements from unmanned aerial vehicles (UAVs) is an emerging and attractive possibility to quantify emissions from localized sources. Here, we present the results of an extensive controlled-release experiment in Dübendorf, Switzerland, which was conducted to develop an optimal quantification method and to determine the related uncertainties under various environmental and sampling conditions. Atmospheric methane mole fractions were simultaneously measured using a miniaturized fast-response quantum cascade laser absorption spectrometer (QCLAS) and an active AirCore system mounted on a commercial UAV. Emission fluxes were estimated using a mass-balance method by flying the UAV-based system through a vertical cross-section downwind of the point source perpendicular to the main wind direction at multiple altitudes. A refined kriging framework, called cluster-based kriging, was developed to spatially map individual methane measurement points into the whole measurement plane, while taking into account the different spatial scales between background and enhanced methane values in the plume. We found that the new kriging framework resulted in better quantification compared to ordinary kriging. The average bias of the estimated emissions was −1 %, and the average residual of individual errors was 54 %. A Direct comparison of QCLAS and AirCore measurements shows that AirCore measurements are smoothed by 20 s and had an average time lag of 7 s. AirCore measurements also stretch linearly with time at an average rate of 0.06 s for every second of QCLAS measurement. Applying these corrections to the AirCore measurements and successively calculating an emission estimate shows an enhancement of the accuracy by 3 % as compared to its uncorrected counterpart. Optimal plume sampling, including the downwind measurement distance, depends on wind and turbulence conditions, and it is furthermore limited by numerous parameters such as the maximum flight time and the measurement accuracy. Under favourable measurement conditions, emissions could be quantified with an uncertainty of 30 %. Uncertainties increase when wind speeds are below 2.3 m s−1 and directional variability is above 33∘, and when the downwind distance is above 75 m. In addition, the flux estimates were also compared to estimates from the well-established OTM-33A method involving stationary measurements. A good agreement was found, both approaches being close to the true release and uncertainties of both methods usually capturing the true release.

Multi-UAV Method for Continuous Source Rate Estimation of Fugitive Gas Emissions from a Point Source

Controlled-release Experiment to Investigate Uncertainties in UAV-based Emission Quantification for Methane Point Sources

Source Seeking Of Multi-Uav With Obstacle Avoidance

A new aerial approach for quantifying and attributing methane emissions: implementation and validation

Source Seeking of UAV Via Adaptive Extremum Seeking Without Steady-state Oscillation

Detection, localization, and quantification of single-source methane emissions on oil and gas production sites using point-in-space continuous monitoring systems

Emission Source Detection and Leak Rate Estimation Using Point Measurements of Concentration

Continuous regional trace gas source attribution using a field-deployed dual frequency comb spectrometer

Towards accurate methane point-source quantification from high-resolution 2D plume imagery

Optimization of sampling structure on unmanned aerial vehicle for gas leakage monitoring in the atmosphere

Resource-aware Probability-based Collaborative Odor Source Localization Using Multiple UAVs

Field Determination of Multipollutant, Open Area Combustion Source Emission Factors with a Hexacopter Unmanned Aerial Vehicle

Optimization of sampling structure on UAV for gas leakage monitoring in the atmosphere

Vertical Distribution Mapping for Methane Fugitive Emissions Using Laser Path-Integral Sensing in Non-Cooperative Open Paths

High-resolution Modelling of Methane Plumes: Validation and Sensitivity Experiments to Explore UAV and Satellite Observations

Dangerous gas traceability route planning for Four- rotor UAV based on the weighted centroid method

E-CONDOR: Efficient Contour-Based Detection Of Random Spatial Signals From UAV Observations Using Dual Stochastic Gradient

Development and Validation of a UAV Based System for Air Pollution Measurements

Simultaneous quantification and changepoint detection of point source gas emissions using recursive Bayesian inference

Gas concentration mapping and source localization for environmental monitoring through unmanned aerial systems using model-free reinforcement learning agents

A Coverage Sampling Path Planning Method Suitable for UAV 3D Space Atmospheric Environment Detection