Abstract:Building Integrated Photovoltaic systems can produce a significant portion of the energy demand of urban areas. Despite their potential, they remain a niche technology that architects and project engineers still find esthetically limited. The dark blue or black color of standard photovoltaic panels is considered inappropriate for restoration projects of historic buildings and represents a major constraint on the development of new projects. This work will provide insight into how the use of optic filters can offer new pathways for architectural acceptance of photovoltaic panels. Optic filters selectively reflect or transmit light by interference and can be designed and fabricated using cost‐effective and industrially compatible processes. By using in‐house developed ray tracing software coupled with TCAD Sentaurus, more than 400 colors were obtained, and their impact on the opto‐electrical performance of interdigitated back‐contacted solar cells was studied. Results show a maximum efficiency loss of 1.6% absolute at the perpendicular incidence of light on the range of obtained colors when compared with a standard dark blue solar cell. Simulations for different angles of incidence showed that the current reduction on the standard device could be modeled using a cosine relationship. The colored cells, however, deviated significantly from this relationship. We propose that the angular behavior of any cell (colored or standard) could be simulated by modifying the effective irradiance with scaling factors equal to the ratios of the photogenerated current at any angle with respect to the value at normal incidence. We demonstrate that this approach accurately models the effect of the color filter and allows for an easy transition from a bare cell to an encapsulated one. Due to the spectral effect of the filter, we developed both a spectrally resolved optical model and a two‐dimensional finite volume transient thermal model. In case of the optical model, we demonstrate an accuracy in the prediction of the reflectance produced by the color with values of mean bias error (MBE) between 2.0% and 3.9%. As for the thermal model, it was validated by first analyzing a standard model under conditions of nominal operating cell temperature and then comparing its results with published scientific literature. Later, we compare its prediction against 2 weeks of measurements. In both cases the thermal model proves an adequate accuracy, yielding differences below 1.5°C with respect to other scientific works and an MBE value of 0.89°C as well as a root‐mean‐square error value of 2.10°C for the entire measurement period. With the validated models, we studied the effect of the encapsulation on the color perception. We present two options of color filters. The first one produces relatively low reflectance losses and presents relative annual direct current (DC) energy losses of up to 6.4% for Delft, in the Netherlands, and up to 5.9% for Alice Springs in Australia. However, this first option has very poor color brightness. The second studied filter produces highly saturated bright colors. Improving brightness can increase the annual DC relative losses up to 13.7% and 13.5% for Delft and Alice Springs, respectively. Overall, we demonstrate that colored filters based on multilayer optical stacks are a versatile option for coloring cells that allow a good compromise between esthetics and performance. We present a modeling framework for performance assessment of colored solar cells. Sentaurus TCAD simulations showed that application of optic filters to produce colored interdigitated back‐contacted (IBC) solar cells produces relatively low impact on efficiency. In‐house developed ray tracing software was used to study the behavior of colored cells. The proposed methods demonstrate that cell to system modeling is possible using scaling factors and the two‐diode model. Simulations show that colors can produce relative annual yield losses ranging from 2% to 11%.

A Dielectric Multilayer Filter for Combining Photovoltaics with a Stirling Engine for Improvement of the Efficiency of Solar Electricity Generation

Investigation of a broadband TiO2/SiO2 optical thin-film filter for hybrid solar power systems

Organic Solar Cells: A New Interconnecting Layer of Metal Oxide/Dipole Layer/Metal Oxide for Efficient Tandem Organic Solar Cells (adv. Energy Mater. 17/2015)

Analysis of the spatial filter of a dielectric multilayer film reflective cutoff filter-combination device

Hybrid System for Solar Energy Conversion with Nano-Structured Electrodes

Performance Optimization of Silicon Cells by Solar Spectrum Splitting Technology

Highly Efficient Semitransparent Solar Cells with Selective Absorption and Tandem Architecture.

Demonstration of a novel dispersive spectral splitting optical element for cost- effective photovoltaic conversion

Practical design of an optical filter for thermal management of photovoltaic modules

Integration of tunable solar spectral directional absorption and switchable near-infrared transmission filters based on phase-change materials

Photo-thermo-electric Modeling of Photon-Enhanced Thermionic Emission with Concentrated Solar Power

Solar-Blind Ultraviolet Band-Pass Filter Based on Metal-Dielectric Multilayer Structures

Enhancing photovoltaic solar panel performance with integration of PCM-based spectral filter and self-cleaning coating

High Efficient and Wide-Angle Solar Absorption with a Multilayered Metal-Dielectric Film Structure

Multilayered Metal-Dielectric Film Structure for Highly Efficient Solar Selective Absorption

A Side-Absorption Concentrated Module with a Diffractive Optical Element as a Spectral-Beam-Splitter for a Hybrid-Collecting Solar System

Colored optic filters on c‐Si IBC solar cells for building integrated photovoltaic applications

Numerical and Experimental Investigation of Infrared Optical Filter Based on Metal Oxide Thin Films for Temperature Mitigation in Photovoltaics

Enhanced spectral splitting in a novel solar spectrum optical splitter based on one dimensional photonic crystal heterostructure

Integrated Silicon-Based Spectral Reshaping Intermediate Structures for High Performance Solar Thermophotovoltaics

Multi-scale multi-physic coupled investigation on the matching and trade-off of conversion and storage of optical, thermal, electrical, and chemical energy in a hybrid system based on a novel full solar spectrum utilization strategy