Abstract:The central element of a phased array antenna that performs beam electrical scanning, as well as signal transmission and reception, is the transceiver (T/R) module. Higher standards have been set for the integration, volume, power consumption, stability, and environmental adaptability of T/R modules due to the increased operating frequency of phased array antennas, the variability of application platforms, and the diversified development of system functions. Device-based multichannel T/R modules are the key to realizing low-profile Ka-band phased array antenna microsystem architecture. The design and implementation of a low-profile, high-performance, and highly integrated Ka-band phased array antenna T/R module are examined in this paper. Additionally, a dependable Ka-band four-channel T/R module based on Si/GaAs/Low Temperature Co-fired Ceramic (LTCC), applying multi-material heterogeneous integration architecture, is proposed and fabricated. The chip architecture, transceiver link, LTCC substrates, interconnect interface, and packaging are all taken into consideration when designing the T/R module. When compared to a standard phased array antenna, the module's profile shrunk from 40 mm to 8 mm, and its overall dimensions are only 10.8 mm × 10 mm × 3 mm. It weighs 1 g, and with the same specs, the single channel volume was reduced by 95%. The T/R module has an output power of ≥26 dBm for single-channel transmission, an efficiency of ≥25%, and a noise factor of ≤4.4 dB. When compared to T/R modules based on System-on-Chip (SOC) devices, the RF performance has significantly improved, as seen by an increase in single channel output power and a decrease in the receiving noise factor. This work lays a foundation for the devitalization and engineering application of T/R modules in highly reliable application scenarios.

A Ka-band transceiver front-end module for wide band wireless communication

A Compact 2-18Ghz Ultra-Wideband Frequency-conversion T/R Module Based on a 3D Heterogeneous Integrated Process

Design and Fabrication of a TR Microsystem in Ka Band with Si-Based 3D Heterogeneous Integration

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

Development of Transceiver RF Front-Part System Module for Ka-Band Coherent Radar

Design of a Ka-Band Heterogeneous Integrated T/R Module of Phased Array Antenna

220 GHz Multi Circuit Integrated Front End Based on Solid-State Circuits for High Speed Communication System

A Millimeter T/R Modules with High-Gain and High Power

A Ka-Band 4TX/4RX Dual-Stream Joint Radar-Communication Phased-Array CMOS Transceiver

An Integrated K-Band Receiving Front-End Module for Satellite Communication

Real-time Intra-symbol Two-stage Bit-class Distribution Matcher-based PS-64QAM DMT Transceiver for W-band Wireless Transmission

A 29-to-36 GHz 4TX/4RX Dual-stream Phased-array Joint Radar-Communication CMOS Transceiver Supporting Centimeter-level 2D Imaging and 64-QAM OTA Wireless Link

A Fully Integrated QPSK/16-QAM D-Band CMOS Transceiver With Mixed-Signal Baseband Circuitry Realizing Digital Interfaces

A MMW T/R front-end for TDD radio systems

A Fully Integrated Bit-to-Bit 24/48Gb/s QPSK/16-QAM D-Band Transceiver with Mixed-Signal Baseband in 28nm CMOS Technology.

A Baseband Transceiver for Multi-Mode and Multi-Band SoC.

A Fully Integrated Bit-to-Bit 24/48gb/s QPSK/16-QAM D-Band Transceiver with Mixed-Signal Baseband in 28nm CMOS Technology

A Ka-Band Single-Chip SiGe BiCMOS Phased-Array Transmit/Receive Front-End

A G-Band Wideband Bidirectional Transceiver Front-End in 40-Nm CMOS

A 35-Ghz TX and RX CMOS Front-Ends for Ka-Band FMCW Phased-Array Radar Transceivers