Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Effect of Pt/γ-Al2O3 Catalyst on Nonthermal Plasma Decomposition of Benzene and Byproducts

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Plasma-catalyst Hybrid Reactor with CeO2/γ-Al2O3 for Benzene Decomposition with Synergetic Effect and Nano Particle By-Product Reduction

Successive treatment of benzene and derived byproducts by a novel plasma catalysis-adsorption process

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

A Comparison Study of Toluene Removal by Two-Stage DBD-catalyst Systems Loading with MnO X , CeMnO X , and CoMnO X

Chlorobenzene Removal Using DBD Coupled with CuO/γ-Al2O3 Catalyst

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Post Plasma-Catalysis of Low Concentration VOC Over Alumina-Supported Silver Catalysts in a Surface/Packed-Bed Hybrid Discharge Reactor

DBD coupled with MnOx/gamma-Al2O3 catalysts for the degradation of chlorobenzene

Effects of Pretreatment Atmospheres on the Catalytic Performance of Pd/γ-Al2O3 Catalyst in Benzene Degradation

Decomposition of Trace Chlorobenzene over V2O5-WO3/TiO2-based Catalysts in Simulated Flue Gas

Benzene Removal Using Non-thermal Plasma with CuO/AC Catalyst: Reaction Condition Optimization and Decomposition Mechanism

Degradation of Benzene by a Falling Film Gas–Liquid Phase DBD Plasma with Persulfate

Effects of Atmosphere Pretreatment on the Catalytic Performance of Pd/γ-Al2O3 Catalyst in Benzene Degradation II: Crystal Structure Transformation of Pd Active Species

Decomposition of gaseous chlorobenzene using a DBD combined CuO/ α-Fe2O3 catalysis system

Study on the degradation of o-dichlorobenzene by DBD-NTP co-modified titanium gel catalyst

Destruction of Benzene in an Air Stream by the Outer Combined Plasma Photolysis Method

Abatement of chlorobenzene by plasma catalysis: Parameters optimization through response surface methodology (RSM), degradation mechanism and PCDD/Fs formation

Optimization for Plasma-facilitated Catalytic Reduction of NO_x

Study on the parameters of non-thermal plasma degradation process based on the combination of simulation and experiment