Abstract:Human being faces two key problems: world-wide energy shortage and global climate worming. To reduce energy consumption and carbon emission, it needs to develop high efficiency heat transfer devices. In view of the fact that the existing enhanced technologies are mostly developed according to the experiences on the one hand, and the heat transfer enhancement is normally accompanied by large additional pumping power induced by flow resistances on the other hand, in this chapter, the field synergy principle for convective heat transfer optimization is presented based on the revisit of physical mechanism of convective heat transfer. This principle indicates that the improvement of the synergy of velocity and temperature gradient fields will raise the convective heat transfer rate under the same other conditions. To describe the degree of the synergy between velocity and temperature gradient fields a non-dimensional parameter, named as synergy number, is defined, which represents the thermal performance of convective heat transfer. In order to explore the physical essence of the field synergy principle a new quantity of entransy is introduced, which describes the heat transfer ability of a body and dissipates during hear transfer. Since the entransy dissipation is the measure of the irreversibility of heat transfer process for the purpose of object heating the extremum entransy dissipation (EED) principle for heat transfer optimization is proposed, which states: for the prescribed heat flux boundary conditions, the least entransy dissipation rate in the domain leads to the minimum boundary temperature difference, or the largest entransy dissipation rate leads to the maximum heat flux with a prescribed boundary temperature difference. For volume-to-point problem optimization, the results indicate that the optimal distribution of thermal conductivity according to the EED principle leads to the lowest average domain temperature, which is lower than that with the minimum entropy generation (MEG) as the optimization criterion. This indicates that the EED principle is more preferable than the MEG principle for heat conduction optimization with the purpose of the domain temperature reduction. For convective heat transfer optimization, the field synergy equations for both laminar and turbulent convective heat transfer are derived by variational analysis for a given viscous dissipation (pumping power). The optimal flow fields for several tube flows were obtained by solving the field synergy equation. Consequently, some enhanced tubes, such as, alternation elliptical axis tube, discrete double inclined ribs tube, are developed, which may generate a velocity field close to the optimal one. Experimental and numerical studies of heat transfer performances for such enhanced tubes show that they have high heat transfer rate with low increased flow resistance. Finally, both the field synergy principle and the EED principle are extended to be applied for the heat exchanger optimization and mass convection optimization.

Geometry Optimization of Self-Similar Transport Network

Minimum Entransy Dissipation Principle for Optimization of Transport Networks

Flow optimization process in a transportation network

Multi-dimensional Effect on Optimal Network Structure for Fluid Distribution

Optimization Analysis Of Thermal Network Layout

Design of Microfluidic Channel Networks with Specified Output Flow Rates Using the CFD-based Optimization Method

Heuristic optimality criterion algorithm for topology optimization of conjugate heat transfer problem

Application of Entransy Optimization to One-Stream Series-Wound and Parallel Heat Exchanger Networks

Application of Entransy to Optimization Design of Parallel Thermal Network of Thermal Control System in Spacecraft

Net-based topology optimization approach for cooling channels

Topology optimization of heat sink based on variable density method

Entransy dissipation, entransy-dissipation-based thermal resistance and optimization of one-stream hybrid thermal network

Topology Optimization of Turbulent Flow Cooling Structures Based on the k-ε Model

Heat Spreading Effect on the Optimal Geometries of Cooling Structures in A Manifold Heat Sink

Novel Approaches To Optimization Of Heat Conduction And Convection

Optimization Strategies of Heat Transfer Systems with Consideration of Heat Transfer and Flow Resistance

Entransy Dissipation Analyses Of Series-Wound And Parallel Thermal Networks

Topology optimization of heat source distribution for volume-to-point heat conduction

Optimal Mixing in Transport Networks: Numerical Optimization and Analysis

Numerical simulation of optimal transport paths

Optimization Principles For Heat Convection