Numerical investigation on film cooling characteristics of slot-sectional diffusion holes combined with an internal cross-flow channel
Guang-Yao Xu,Bai-Tao An,Zhi-Qiang Yu,Chen Li
DOI: https://doi.org/10.1016/j.applthermaleng.2020.115953
IF: 6.4
2020-11-01
Applied Thermal Engineering
Abstract:<p>Film cooling characteristics of several slot-sectional diffusion hole geometries were investigated in a perpendicular cross-flow channel using numerical methods. A traditional circle-sectional fan-shaped hole was compared as a baseline. Four slot-sectional hole geometries included two fusiform diffusion holes (upstream or downstream wall outer convex) and two rectangular diffusion holes (cross-sectional aspect ratio AS = 3.5 or 5.0). The cross-flow channel had an 8D × 8D square cross-section and divided into smooth, 45° rib and 135° rib channels. Compared with plenum-fed, the film cooling effectiveness profiles of the slot-sectional diffusion holes were all transformed to asymmetric bi-peak patterns under the influences of cross-flow. Compared with the fan-shaped hole, a considerable advantage in film cooling effectiveness was found, especially at moderate and high blowing ratios. The largest increase in spatially averaged effectiveness was 160%, 112% and 50% respectively in the smooth, 45° rib and 135° rib channel. The rectangular hole with a large cross-sectional aspect ratio always yielded the highest cooling effectiveness in the different cross-flow channels. ln the ribbed channels, the performance of the post rib hole was significantly higher than that of the pre rib hole. The discharge coefficients of the slot-sectional diffusion holes were slightly higher than the fan-shaped hole in the same cross-flow channel.</p>
energy & fuels,engineering, mechanical,thermodynamics,mechanics