Abstract:The lack of reliable testing methods and standards hinders systematic research on the impact fatigue performance of materials. The aim of developing an impact fatigue test method is to generate repeated impact loads with a constant amplitude, which is difficult to achieve using various existing impact test devices. This study investigated the principles of cyclic loading-resetting and constant-amplitude loading based on the split Hopkinson pressure bar (SHPB) system, established a novel impact fatigue test device, and verified the developed method by testing the impact fatigue life of a Ti-6Al-4V alloy. Electromagnetic valves, laser sensors, and a vacuum pump were used in the developed device to launch and reset the striker bar; a servo motor and laser sensors were used to reset the loading bars and specimen, and the entire system was controlled by a programmable controller to achieve continuously repeated loading. To achieve constant-amplitude loading, the conditions required to ensure that the specimen moves away from the incident bar before the returning stress wave reloads the specimen was derived. It was found that a constant-amplitude repeated impact on the specimen could only be achieved through the precise design of the geometric configuration and material of the loading bars. This method is considerably simpler than various existing methods based on energy absorption and is more applicable to impact fatigue tests. The verification tests showed that the highest loading frequency of the device was 0.5 Hz, the loading rate exceeded 105 kN/s, and the amplitude error of the repeated impact loads did not exceed 2.45 %. Under loads with the same amplitude, the impact fatigue life of a Ti-6Al-4V alloy was considerably shorter than the non-impact (low strain rate) fatigue life, which indicates the necessity of investigating the strain rate effect on the fatigue performance of materials.

Mechanical Impact Test and Analysis Based on Anti High Overload Acoustic Sensor

Theoretical Analysis Of The Dynamic Properties Of A 2-2 Cement-Based Piezoelectric Dual-Layer Stacked Sensor Under Impact Load

Design of a Continuously Repeated Impact Method with Constant Amplitude Based on Hopkinson Bar: Principle and Impact Fatigue Life Testing

Finite element inverse solving method of impact identification for a piezoelectric smart structure

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

Force Acquisition for Impact Tester

Impact Detection Based On in-Situ Direct Writing Piezoelectric Polymer Sensor Array

Impact contact mechanical characteristics assessment of piezoelectric material using the semi-analytical method

Study on Dynamic Mechanical Behavior of MEMS Based on Free Hopkinson Pressure Bar

Analysis of Dynamic Properties of Piezoelectric Structure under Impact Load

Impact Damage Detection in Composite Laminates Using PVDF and PZT Sensor Signals

IMPACT EXPERIMENT ANALYSIS OF MEMS ULTRA-HIGH G PIEZORESISTIVE SHOCK ACCELEROMETER

Frequency Wavenumber Design of Piezoelectric Sensors for Impact Monitoring

Design, Simulation and Fabrication of Triaxial MEMS High Shock Accelerometer

Structural Design of MEMS Acceleration Sensor Based on PZT Plate Capacitance Detection

A Double-End Fixed Beam Structure of MEMS Piezoresistive High G Accelerometer

Design and Simulation of High-g Value and Long Pulse Impact Test Device

Contact Force Measurement and Response to Damage of Composite Laminates Subjected to Small-mass Impact

A Real-time Impact Monitoring System for Composite Structures

Developing Status and Trend of High Impact Accelerometer

Research on Overload Signal of New Impact Body Based on Air Cannon Test and Simulation