Abstract:It is a great challenge to detect in-situ high-frequency vibration signals for extreme environment applications. A highly sensitive and robust vibration sensor is desired. Among the many piezoelectric materials, single-crystal lithium niobate (LiNbO3) could be a good candidate to meet the demand. In this work, a novel type of micro-electro-mechanical system (MEMS) vibration sensor based on a single crystalline LiNbO3 thin film is demonstrated. Firstly, the four-cantilever-beam MEMS vibration sensor was designed and optimized with the parametric method. The structural dependence on the intrinsic frequency and maximum stress was obtained. Then, the vibration sensor was fabricated using standard MEMS processes. The practical intrinsic frequency of the as-presented vibration sensor was 5.175 kHz, which was close to the calculated and simulated frequency. The dynamic performance of the vibration sensor was tested on a vibration platform after the packaging of the printed circuit board. The effect of acceleration was investigated, and it was observed that the output charge was proportional to the amplitude of the acceleration. As the loading acceleration amplitude is 10 g and the frequency is in the range of 20 to 2400 Hz, the output charge amplitude basically remains stable for the frequency range from 100 Hz to 1400 Hz, but there is a dramatic decrease around 1400 to 2200 Hz, and then it increases significantly. This should be attributed to the significant variation of the damping coefficient near 1800 Hz. Meanwhile, the effect of the temperature on the output was studied. The results show the nearly linear dependence of the output charge on the temperature. The presented MEMS vibration sensors were endowed with a high output performance, linear dependence and stable sensitivity, and could find potential applications for the detection of wide-band high-frequency vibration.

Design and fabrication of a piezoelectric sensor for weighing in motion

Analysis and research of piezoelectric dynamic weighing sensor

Identification of a Moving Mass on a Beam Bridge Using Piezoelectric Sensor Arrays

Identification of Static Loading Conditions Using Piezoelectric Sensor Arrays

Development and Temperature Correction of Piezoelectric Ceramic Sensor for Traffic Weighing-In-Motion

Research on Special Piezoresistive Acceleration Sensor

A High-Performance Weighing Sensor Based on Surface Acoustic Wave Technology

Development of a Novel Piezoelectric Sensing System for Pavement Dynamic Load Identification

A novel piezoelectric 6-component heavy force/moment sensor for huge heavy-load manipulator's gripper

Design, fabrication, and characterization of a high-sensitivity integrated quartz vibrating beam accelerometer

Design of a Biaxial High-G Piezoresistive Accelerometer with a Tension–Compression Structure

Research and Design of vehicle Dynamic Weighing System Based on Piezoelectric Quartz Sensor

A novel parallel piezoelectric six-axis heavy force/torque sensor

A Two-Axis MEMS Piezoresistive In-Plane Accelerometer with Pure Axially Deformed Microbeams

Design And Simulation Of A Novel Piezoresistive Accelerometer For High Accuracy And Overload Ability

Design of a Piezoelectric Accelerometer with High Sensitivity and Low Transverse Effect

A High Overloaded Piezoresistive Accelerometer Based on SOI Materials with Cantilever Beam

(Invited) Design and Simulation of a Novel Shock Accelerometer Based on Giant Piezoresistance Effect

Design and Performance Test of MEMS Tri-Axial Micro-Force Probe Sensor

High-Performance Piezoelectric-Type MEMS Vibration Sensor Based on LiNbO3 Single-Crystal Cantilever Beams

A High-Performance Micromachined Piezoresistive Accelerometer with Axially Stressed Tiny Beams