Abstract:Notice of Retraction After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE's Publication Principles. We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper. The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org. The applicability to use the method of metal adsorption followed by selective extraction for the determination of heavy metal, Pb and Cd, adsorption contributions of natural surface coating components was tested in this study, by comparing this method with the traditional method of selective extraction followed by metal adsorption. Results indicated that compared to the method of extraction before adsorption, the concentration of Pb and Cd on each component of surface coatings used the method of adsorption before extraction was lower, and near to the detection limit. The very weak adhesion of Pb and Cd onto surface coatings was the main reason, while the extractant reagents removed Pb an Cd in specific adsorbing phases, the Pb and Cd adsorbed on other components was removed too, so the adsorption before extraction was not suitable for the studies concerning metal adsorption to surface coatings in the laboratory. However it is suitable for the studies concerning the enriched heavy metal distribution in different components of surface coatings when they were developed in natural water.

Notice of Retraction Applicability to Use the Method of Adsorption Followed by Extraction to Determine the Contribution of Surface Coating Components to Metal Adsorption