Abstract:Pt/cobalt-polypyrrole-carbon(Co-PPy-C)-supported catalysts were successfully prepared by pulse-microwave assisted chemical reduction. Transmission electron microscopy(TEM), X-ray photoelectron spectroscopy(XPS), and X- ray diffraction(XRD) techniques were used to characterize the catalyst microstructure and morphology. The electrocatalytic performance, kinetic characteristics of the oxygen reduction reaction(ORR), and durability of the catalysts were measured by cyclic voltammetry(CV) and linear sweep voltammetry(LSV) techniques. It was found that the particle size of Pt/Co-PPy-C was about1.8 nm, which was smaller than that of commercial Pt/C(JM) catalysts(2.5 nm). The metal particles were well-dispersed on the carbon support. The electrochemical specific area(ECSA) of Pt/Co-PPy-C(75.1 m2·g-1) was much higher than that of Pt/C(JM)(51.3 m2·g-1). The results of XPS showed that most of the Pt in the catalysts was in the Pt(0) state, and XRD results showed that the form of Pt was mainly the facecentered cubic lattice. The Pt/Co-PPy-C catalyst had the same half-wave potential as Pt/C(JM) and showed higher ORR activity. The Pt/Co-PPy-C catalyst proceeded by an approximately four-electron pathway in acid solution. After 1000 cycles of CV, the ECSA attenuation rates of Pt/Co-PPy-C and Pt/C were 13.0% and 24.0%respectively, which means that the Pt/Co-PPy-C catalyst has higher durability. The high performance of Pt/Co-PPy-C makes it a promising catalyst for proton exchange membrane fuel cells.

Preparation and characterization of a Pt/AC catalyst

Preparation of Pt catalyst for the treatment of condensate wastewater

Influence of Preparation Condition on the PdHx Phase of Pd/C Catalyst

Notice of Retraction Preparation and Characterization of a Pt/AC Catalyst

Effects of Pre-Treatment of Supports on Pt/AC Activity

High Catalytic Performance and Stability of Pt/C Using Acetic Acid Functionalized Carbon

Preparation, Characterization and Catalytic Activity of Pt/graphite Catalyst

Preparation and Characterization of Pt Catalysts Supported on Cobalt-Polypyrrole-Carbon for Fuel Cells

Study on Preparation of Pt/GAC Catalyst and Catalyzing Oxidation Condensate Wastewater

The Effect of Preparation Method on the Performance of PtSn/Al2O3 Catalysts for Acetic Acid Hydrogenation

Effect of Acid Treatment on Electrocatalytic Performance of PtNi Catalyst

Preparation and characterization of a oxidation resistant active carbon

Pt Structured Catalysts Prepared Using a Novel Competitive Impregnation Method for the Catalytic Combustion of Propionic Acid

Effect of Preparation Conditions on the Catalytic Performances of PtRu/CAs Catalysts for Methanol Electro-oxidation

PREPARATION AND CHARATERIZATION OF PLATINUM/ACTIVATED CARBON CATALYSTS FOR HIDECOMPOSITION

Preparation and Characterization of Pt/C Catalysts Stabilized by Ethylene Glycol

PREPARATION OF PALLADIUM/CARBON CATALYSTS FOR PURIFICATION OF TEREPHTHALIC ACID

Effect of Preparation Method on the Performance of Pt–Au/TiO2 Catalysts for the Catalytic Co-Oxidation of HCHO and CO

Effect of Preparation Methods on the Performance of Pt/CeO2 Catalysts for the Catalytic Oxidation of Carbon Monoxide

Synthesis and characterization of Pt/MCM-41 catalysts

Preparation and Characterization of Pt-WO 3 /C Catalysts for Direct Ethanol Fuel Cells