Study on Technique of Finite-Difference Grid Subdivision in Three Dimensional Pre-Processing System

LIN Geng-hao,MA Tian-bao,NING Jian-guo
2011-01-01
Abstract:According to the computational grids of 3D fluid-elastoplastic computational procedures MMIC3D are orthogonal hexahedral grids,an automatic software of grids subdivision MESH-3D is developed,which can realize complicated solid modeling,and subdivide solid models into finite-difference grids.Two kinds of modeling methods,CSG and STL model,are used in MESH-3D.MESH-3D subdivide CSG solid models into finite-difference grids through calculating contour lines layer by layer,subdivides STL models into finite-difference grids through using Edge-based integral slice algorithm and refer to the scanning line filling technique of computational graphics.Finally,the reasons why MESH-3D subdivides STL models into finite-difference grids faster than subdivides CSG solid models are analyzed.This process is conductive to other calculations and post-processing display.
What problem does this paper attempt to address?