Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Evaluation of Distortion of Castings

Machining Distortion Prediction of Aerospace Monolithic Components

Extraction of Deformation of Castings from Simulated Displacement Results

Three Dimensional Dynamical Measurement of Distortion of Heavy Steel Castings During Heat Treatment Process

Integrated Simulation of Castings Deformation during Casting and Heat Treatment Processes

Description of component distortion in aluminum gravity die casting as a result of hindered shrinkage and evaluation of numerical predictionsUntersuchung des Bauteilverzugs beim Aluminium‐Kokillenguss als Folge der behinderten Schrumpfung und Evaluierung von numerischen Vorhersagen

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

A Real-Time Measuring Technology for Studying Distortion of Hydraulic Turbine Blade Castings During Heat Treatment Process

Numerical Simulation of Deformation in Large Scale Hydroturbine Blade Casting

The molding analysis of automobile parts using the die-casting system

Deformation Prediction of A Heavy Hydro Turbine Blade During the Casting Process with Consideration of Martensitic Transformation

Development of an Experimental Setup to Investigate Influences on Component Distortion in Gravity Die Casting and a First Variation of Temperature Control Strategy

Iterative reverse deformation optimization design of castings based on numerical simulation of solidification thermal stress

Through Process Numerical Simulation of a Heavy Hydro Turbine Blade Casting

Development of a hybrid method for improved accuracy of mould filling computational models for castings

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Active and Passive Deformation of Large Thin-Walled Workpiece in Heat Treatment Process

A Method for Straightening Distorted Giga-Cast Large Thin-Walled Components

Towards a comprehensive understanding of distortion in additive manufacturing based on assumption of constraining force

Surface Temperature Difference for Analysis of Distortion of Heavy Weak-Rigidity Castings During Heat Treatment

Stress Analysis and Deformation Prediction of a Heavy Hydraulic Turbine Blade Casting During Casting and Heat Treatment