Abstract:Diamond-like carbon (DLC) coatings have attracted much attention due to their excellent hardness, low friction, and superior corrosion resistance. Unfortunately, the poor adhesion caused by internal stress limits the typical thickness to below 3-5 mu m. This paper presents a novel interlayer design and interface engineering and the induced excellent adhesion of thick diamond-like carbon (DLC) coatings on a high speed steel substrate. The interlayer has fundamentally a graded Cr/CrCx/CrC/DLC structure, but various treatments to the hetero-interfaces have been conducted including sequential energetic ion bombardments with Cr at the substrate/Cr interface using high-power impulse magnetron sputtering (HiPIMS) and with C at the CrC/DLC interface using an anode layer ion source. It has been observed that the critical load has been improved from 18 N for a single Cr interlayer to 77 N for a Cr/CrCx/CrC interlayer for thick DLC coatings of 13 mu m. Using the same design, a very high critical load of 73 N has been achieved on the ultra-thick DLC coating of 50 mu m. This interlayer design has allowed the deposition of a DLC coating that is not only thick but also hard with excellent tribological properties. The DLC coatings have a high hardness of > 18 GPa, a low friction coefficient of 0.12 and a low wear rate of (1.7 +/- 0.2) x 10(-15) m(3)/N.m. This paper discusses the effect of the ion bombardment of the interlayer on the coating adhesion and the strengthening mechanisms. (C) 2017 Elsevier B.V. All rights reserved.

Improvement of Environmental Stability of Carbon Nanotube Cold Cathode with Diamond-Like Carbon Coating

Field Emission Property of CNT Cold Cathode with DLC Film Deposition Treatment

Dependence of Optimum Thickness of Ultrathin Diamond-like Carbon Coatings over Carbon Nanotubes on Geometric Field Enhancement Factor

Enhanced Field Emission Properties of Carbon Nanotubes by Coating Diamond-Like Carbon Layer

Enhancement of Sp3 C Fraction in Diamond-like Carbon Coatings by Cryogenic Treatment

Effect of growth environment on carbon nanotubes film

The Effect of Amorphous Carbon Layer on the Field Emission Characteristics of Carbon Nanotube Film.

Large improvement of the tensile strength of carbon nanotube films in harsh wet environments by carbon infiltration

Electrochemical Characterization of Diamond Like Carbon Thin Films

Magnetron Sputtering Preparation of Diamond-Like Carbon Film Adhesion Characteristics Research

Effect of Nitrogen Doping on the Microstructure and Thermal Stability of Diamond-Like Carbon Coatings Containing Silicon and Oxygen

Achieving Excellent Thermally Conductive and Electromagnetic Shielding Performance by Nondestructive Functionalization and Oriented Arrangement of Carbon Nanotubes in Composite Films

Research Progress of Metal Doped Diamond-like Carbon Films

Surface Characteristics and Electrochemical Corrosion Behavior of NiTi Coated with Diamond-Like Carbon

Microstructure and Tribological Properties of Diamond-Like Carbon and Tialsicn Nanocomposite Coatings

Improvement of the field emission of carbon nanotubes by hafnium coating and annealing

Inhibition effect of covalent carbon nanosheets on mechanochemical wear of diamond

Improvement of Luminescent Stability from Carbon Nanotube Field Emission Display Based on Printed CNT Film

Electrodeposition, microstructure and tribological performance of Ni/(N) incorporated diamond-like carbon films

Research on Electrochemical Behaviors of Diamond-Like Carbon Film Electrodes

Excellent Adhered Thick Diamond-Like Carbon Coatings by Optimizing Hetero-Interfaces with Sequential Highly Energetic Cr and C Ion Treatment