Research on Matching of Railway Wheel and Rail Profiles

ZHAO Wei,WANG Chun-yan,ZHANG Jun,DU Li-ming

DOI: https://doi.org/10.3969/j.issn.1001-8360.2011.02.006

2011-01-01

Abstract:General profiles chosen from worn wheel profiles and railheads(old wheel and rail profile for short) measured by the wheel-rail profile admeasuring apparatus were used to build the finite element models,and the new/old wheel-rail contact problems were analyzed respectively.Through calculation the areas,shapes and positions of the contact spots and the changing laws of distribution of contact forces and ecuivalent stresses were generalized for different wheel-rail contact models,and the reasons of the old wheel rail rag generation were found.The results show as fdlows: for the model of new wheel and old rail,the contactspot area is small,the peak point of the equivalent stress is large and the contact position is on two sides of the railhead,which indicates that cutting the old wheel tread to the original profile is unjustifiable;compared with other models,the contact model of the old wheel and old rail has the largest contact spot area and best wheel-rail matching,which indicates design of the wheel tread turned to adapt to the old railhead profile is of significance to reduce wear of the wheel tread and railhead profile.