Iterative optimization method for injection parameters based on surrogate model

Peng Zhao,FU Jian-zhong,Yang Li,CUI Shu-biao

DOI: https://doi.org/10.3785/j.issn.1008-973X.2011.02.001

2011-01-01

Abstract:Cavity pressure and temperature difference are two important quality criteria. Considering that most injection molded parts have a sheet like geometry, a fast strip analysis model based on mechanics equations for viscous fluid, was adopted as a surrogate model to approximate the time-consuming computer simulation software for predicating the above quality criteria. According to the predicted quality criteria, a particle swarm optimization algorithm was employed to find out the optimum injection parameters. The proposed optimization method can optimize the injection parameters in short time and it does not rely on any knowledge of molding process. Finally, two experiments were employed to validate the surrogate model and the proposed optimization method. Experimental results show that the cavity pressure predicted by the surrogate model agree well with the experimental data, with the relative error being less than 8.41%, and the results of the proposed optimization method are nearly identical to that of response surface method, while the required time of the proposed method is only 0.02% of that of response surface method.