Abstract:In order to achieve high working efficiency, modern gas turbines operate at high temperature which is close to the melting points of metal alloys. However, the support of turbine end suffers the thermal deformation. And the journal center position is also changed due to the effects of high temperature and shaft gravity. Tangential or radial supporting structures, which are composed of supporting struts, diffuser cones, hot and cooling fluid channel, are widely used in gas turbine hot end. Cooling technology is usually used to keep the bearing temperature in a reasonable range to meet requirements of strength and deformation of the supporting struts. In this paper, three major assumptions are proposed: (a) radiation is not considered, (b) cooling flow system is only partially modeled and analysis assumes significantly higher cooling flow that is not typical for current engines, and (c) only steady state heat transfer is considered. And a 3D fluid-solid coupled model based on finite -element method (FEM) is built to analyze the performances of both the tangential and the radial support. The temperature distribution, thermal deformation and stress of supports are obtained from CFD and strength analysis. The results show that either the tangential or radial support is used in a 270MW gas turbine; the thermal stress is about 90.3% of total stress which is produced by both thermal effects and shaft gravity. Comparing to the results from radial supports, it can be seen that the struts stress and position variation of journal center of tangential support are smaller. Due to a rotational effect of the bearing housing caused by the deformation of the tangential struts, the thermal stress in these tangential struts can be relieved to some extent. When both thermal effect and shaft gravity are considered, the stress of each tangential supporting strut is almost uniformly distributed, which is beneficial to the stability of rotor system in the gas turbine.

The Strength Reliability Analysis of Periodically Symmetric Struts Supports of Gas Turbine Based on Monte-Carlo Method

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

Study on dynamic response and the effect to center level height of periodic symmetric struts support

Discrete Reliability Analysis Method for Multistage Centrifugal Pump Transmission Structure Based on Sparse Grid Model

Study on Numerical Simulation Method of Periodic Symmetric Struts Support Coupling with Heat Flow and Solid

Data-Driven Probabilistic Thermal Stress Analysis of a Gas Turbine Casing

Numerical Study on Self-Consistency Centering Process of Periodic Symmetric Struts Support

Calculation and Test of Dynamic Stiffness of Gas Turbine Supports

Reliability Analysis of Ground–support Interaction in Circular Tunnels Using the Response Surface Method

Stochastic Isogeometric Analysis for Reliability Evaluation of Shell Structures Based on Multi-scale Support Vector Regression.

A Method For Multiaxial Fatigue Reliability Analysis Based On Mixed Weibull Distribution

Analysis of Static Strength and Fatigue Reliability of the Supporting Structure of Wind Turbine

Advanced Multiple Response Surface Method of Sensitivity Analysis for Turbine Blisk Reliability with Multi-Physics Coupling

A Framework for Fatigue Reliability Analysis of High-Pressure Turbine Blades

Multiobject Reliability Analysis of Turbine Blisk with Multidiscipline under Multiphysical Field Interaction

Data-physics-model based fatigue reliability assessment methodology for high-temperature components and its application in steam turbine rotor

Residual Strength Modeling and Reliability Analysis of Wind Turbine Gear under Different Random Loadings

Probabilistic residual ultimate strength assessment of cracked unstiffened and stiffened plates under uniaxial compression

The Performance Comparison among Common Struts of Heavy-Duty Gas Turbine

Probabilistic Fatigue Life Prediction and Structural Reliability Evaluation of Turbine Rotors Integrating an Automated Ultrasonic Inspection System

Supporting Structure Performances Analysis of Heavy-Duty Gas Turbine Based on Fluid-Solid Coupling Method