Abstract:Using compressible, unsteady and sliding meshing technologies, the aerodynamic loads including transient pressure, lateral force, and overturning moment that are caused by a single train moving through a double-track tunnel or two trains passing each other in a tunnel were calculated. The dynamic response generated by applying these loads to a train body was also analysed. The results show a large difference in the pressure on both sides of the vehicle nose when a single train moves through a double-track tunnel and when two trains pass each other in a tunnel. The pressures at the symmetric measuring points on both sides of the middle of the train body are approximately the same except at the moment of passing. When the train passes the measuring points, the pressure change at the symmetric measuring points on the tunnel wall closer to the train is obviously larger than that farther from the train; the pressure changes are approximately the same at all other times. Therefore, the propagation of the pressure wave in the tunnel has good one-dimensional characteristics. Under dynamic loads in the tunnel, especially those generated by two trains passing each other in the tunnel, the lateral and vertical displacements of the underframe and side walls all increase significantly. The lateral acceleration on the roof is significantly greater than that of the underframe, which has a rolling movement below the centre of gravity. For the measuring points on both the side wall and underframe, the vertical accelerations at both ends are larger than that in the middle of the body because of a pitching motion. The horizontal and vertical vibration acceleration for a train passing another train in a tunnel are 33.8% and 47.2% larger than those for a train operating in open air, respectively.

Aerodynamic Comfort Analysis of High-Speed Trains Passing Each Other at the Same Speed Through a Tunnel

Unsteady Simulation for a High-Speed Train Entering a Tunnel

Aerodynamic effects of a high-speed train travelling through adjoining & separated tunnels

Aerodynamic Study of Two Opposing Moving Trains in a Tunnel Based on Different Nose Contours

Analysis of the Aerodynamic Effects of Different Nose Lengths on Two Trains Intersecting in a Tunnel at 350 Km/h

Numerical Simulation on the Most Unfavorable Tunnel Length of High Speed Trains Passing by Each Other in Tunnel

Comparative Investigations of Pressure Waves Induced by Trains Passing Through a Tunnel with Different Speed Modes

Aerodynamic and Noise Computations of High-Speed Train and Tunnel Interaction

Study on Spatial Distribution of Instantaneous Pressure Pulse Caused by Two Meeting Trains

Aerodynamic forces and moments on high-speed trains passing by each other

Aerodynamic Effects Caused by Trains Entering Tunnels

Comparison Analysis of the Full-Scale Train Tests for Trains with Different Shapes Passing Tunnel

Transient Loads and Their Influence on the Dynamic Responses of Trains in a Tunnel

Numerical Studies on a New Strategy to Mitigate Pressure Waves by Accelerating Trains Through a Long Tunnel

A Study of the Pressure Waves Induced by Two 600 Km/h High-Speed Maglev Trains Intersecting in a Tunnel

Comparative Study on the Unsteady Slipstream Induced by a Single Train and Two Trains Passing Each Other in a Tunnel

Numerical Simulation of Aerodynamic Performance of A Couple Multiple Units High-Speed Train

Numerical analysis on the dynamic airtightness of a railway vehicle passing through tunnels

Numerical Analysis of the Slipstream Development Around A High-Speed Train in A Double-Track Tunnel

Field Measurements of Aerodynamic Pressures in High-Speed Railway Tunnels

Comparative analysis between single-train passing and double-train intersection in a tunnel