Abstract:This paper defines a control method for shift torque exchange stage and a torque distribution control method for speed regulation stage. In the torque exchange stage, the torque distribution problem of active and passive clutches considers the injection of sine curve for local correction, which can solve the fish belly problem of hydraulic response (i.e. the hydraulic response is slow at the beginning and the hydraulic response is fast at the end). In the speed regulation stage, the target speed gradient profile is determined according to different shift types. The determination of the target speed gradient profile integrates different driving modes, throttle, P2 energy and clutch temperature. In the speed regulation stage, the torque distribution control problem of the speed phase including which actuator (P1, engine, C0 clutch) is used preferentially for speed regulation. a) If the speed regulation torque assigned to the input shaft exceeds the input shaft intervention torque capacity, then the excess part is assigned to the clutch for speed regulation. b) If the speed regulation torque assigned to the input shaft is less than the input shaft intervention torque capacity and the speed regulation torque assigned to the input shaft is less than the motor 2 speed regulation torque intervention capacity, the speed regulation torque is assigned preferentially to P2 for lifting torque. The total P2 request torque for P2 is equal to the sum of the speed regulation torque intervention of P2 and the P2 torque requested by ECM because of the fast response and high precision of the motor. c) If the governing torque assigned to the input shaft is less than the input shaft intervention torque capability and the governing torque assigned to the input shaft is greater than the motor 2 governing torque intervention capability, the excess is assigned to the engine. The total engine requested torque is equal to the sum of the engine governing torque intervention and the engine torque requested by the ECM.

The Synchronizing Process Control in Shifting Without Clutch Disengagement of AMT for a Parallel Hybrid Electric Vehicle

Coordinated Control Strategies of HEV Powertrain with AMT

The control algorithm of active synchronization of motor in shifting process for electric vehicles

Torque coordinating robust control of shifting process for dry dual clutch transmission equipped in a hybrid car

Control Analysis and Verification of Synchronizer for Electri-callycontrolled AMT

Simulation of Integrated Gear Shifting Control for Hybrid Electric Vehicle

Shifting Control of Automatic Mechanical Transmissions for Electric Vehicles Based on Optimal Control Theory

Modeling and Analysis of Gear-Shifting Process of Motor-Transmission Coupled Drive System

Integrated and Intelligent Shifting Control of Automated Mechanical Transmission

Electromechanical Coupling Driving Control for Single-Shaft Parallel Hybrid Powertrain

Gear-shifting control of non-synchronizer electric-driven mechanical transmission with active angle alignment

Efficient Mode Transition Control for Parallel Hybrid Electric Vehicle with Adaptive Dual-Loop Control Framework

Coordinated Clutch Slip Control for the Engine Start of Vehicles with P2-hybrid Automatic Transmissions

Shifting Control Strategy Research in the Hard Accelerating Condition Based on the AMT Vehicle

Simulation of AMT autoshift process based on matlab/simulink/stateflow

Hybrid Automata of an Integrated Motor-Transmission Powertrain for Automatic Gear Shift

Research on shifting process control of automatic transmission

A Fuzzy Logic Control-Based Adaptive Gear-Shifting Considering Load Variation and Slope Gradient for Multi-Speed Automated Manual Transmission (AMT) Electric Heavy-Duty Commercial Vehicles

Shifting Schedule and Torque Distribution Strategy for the Plug-in Hybrid Electric Vehicle

Motor Control During Gearshift Phase to Reduce the Oscillation in Dual Hybrid Vehicles

Active Speed-tuning Control in the Process of Gearshift for Heavy PSHEV