Abstract:A three dimensional elastic‐plastic finite element model consisting of a railway crossing and a train wheel was established to investigate the stress/strain field in a high manganese steel crossing nose . Two serv‐ice states of the crossing at a nose width of 50 mm were considered in the paper ,i.e.non‐work hardening cor‐responding to the early service stage and work hardening corresponding to the later service stage ,and the in‐fluence of service work hardening on the magnitude and distribution of stress/strain in the crossing nose was analyzed .In the case of simulation of service work hardening ,a layered model was constructed and various material properties were assigned to corresponding layers ,according to the effect of the distance from the sur‐face of an actual work‐hardened crossing nose on the material properties ,while a homogeneous material prop‐erty was assigned to the entire model with non‐work hardening . The results indicate that ,during both the ear‐ly and later service stages , the von Mises stress and equivalent plastic strain rapidly increase and then gradually decrease with the increase of the depth . As compared with the early service stage , during the later service stage ,the maximum von Mises stress of the crossing nose increased by about 23% ,while the maximum equiv‐alent plastic strain decreased by about 40% ,and the plastic strain zone reduced significantly . The reason for this is due to the largely increased yield strength of the crossing nose after service work hardening .It is there‐ <br> fore believed that the surface quashing and the formation of overlap in the crossing nose may be largely sup‐pressed owing to the service work hardening . Furthermore , as compared to the non‐work‐hardened crossing nose , the distance between the location of the maximum equivalent plastic strain of the work‐hardened crossing nose and the surface of the crossing nose increases from 0.8 mm to 1.5 mm ,indicating that crack initiation site tends to move to locations farther away from the crossing nose surface .

Numerical simulation of stress and deformation in a railway crossing

Three-dimensional Finite Element Simulation on Moving Load Induced Track Response over Stiffness-varied Base

Damage of A Hadfield Steel Crossing Due to Wheel Rolling Impact Passages

Wear of a crossing under dynamic wheel impact

Finite Element Analysis on Contact of Wheel and High Manganese Steel Crossing

Contact stress and residual stress in the nose rail of a high manganese steel crossing due to wheel contact loading

Numerical Analysis of Stress and Strain in a Service-work-hardened High Manganese Steel Crossi ng Nose

Numerical Analysis on Deformation of Pavement and Soft Clay Ground Interaction for Cyclic Loads

Technical Note: Three-dimensional analyses of dynamic responses of track-ground system subjected to a moving train load

Coupling effects of strain rate and fatigue damage on wheel-rail rolling contact behaviour: a dynamic finite element simulation

Analysis of Wheel/Rail Contact Stresses and Rail Corrugation

INFLUENCE OF CROSSING WEAR ON ROLLING CONTACT FATIGUE DAMAGE OF FROG RAIL

Three-dimensional elastic–plastic stress analysis of wheel–rail cyclic rolling contact using finite element method

Analysis of dynamic stresses in ballasted railway track due to train passages at high speeds

On stress and deformation accumulation of continuously welded rails under cyclic thermal loading in high-speed railways

Numerical analysis on the stress field of vehicle chassis of high-speed train under load

Investigation of transient wheel-rail interaction and interface contact behaviour in movable-point crossing panel

Numerical and experimental investigation on critical stresses due to rail cant

Influence of material properties on the high-speed wheel-rail rolling contact behaviour

Fatigue crack growth in wheel-rail rolling-sliding contact: A perspective of elastic-plastic fracture mechanics criterion

Accumulative Deformation in Railway Track Induced by High-Speed Traffic Loading of the Trains