Abstract:The European Union imposed minimum industrial fan efficiency levels in 2013 and then increased them in 2015. In the USA, the Department of Energy (DoE) is also developing regulations aimed at eliminating inefficient industrial fans from the market by 2023. A consequence of this regulatory activity is a need to apply design methods originally developed within the aerospace community to the design of high efficiency industrial fans. In this paper, we present a process used to design, numerically verify and experimentally test a high-pressure single-stage axial fan. The goal was a fan design capable of working over a range of blade angles in combination with a single fixed cambered plate stator. We present the process used when selecting blade airfoil sections and the vortex distribution along the blade span. The selected methodology is based on a coupling between the aerodynamic response of each blade profile and the chosen vortex distribution, creating a direct link between the load distribution and the aerodynamic capability of the blade profile section. This link is used to develop radial distributions of blade twist and chord for the selected blade profiles that result in the required radial work distribution. The design method has been enhanced through intermediate verifications using two different numerical methodologies. The methodologies are based on different approaches, in so doing providing confidence in the verification process. The final blade design has been analyzed using a three-dimensional computational fluid dynamic (CFD) code. Results of the CFD analysis indicate that performance of the final blade design is consistent with the design specifications. The paper concludes with a comparison between predicted and experimentally measured performance. The need is clarified for balance between computational and empirical approaches. When used together the development effort results in a lower cost and higher efficiency design than would have been possible using either approach in isolation.

Design of a Highly Loaded Transonic Two-Stage Fan Using Swept and Bowed Blading

The Blade Shape Optimization of a Low-Pressure Axial Fan Using the Surrogate-Based Multi-Objective Optimization Method

An Optimization on the Stacking Line of Low-Pressure Axial-Flow Fan Using the Surrogate-Assistant Optimization Method

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Aerodynamic Optimization of a Transonic Fan Rotor by Blade Sweeping Using Adaptive Gaussian Process

A design method of volute profile of multi-blade centrifugal fan based on DRBF model

Basic Analysis on the Design of an Fan Stage With Axial Supersonic Through-Flow Rotor

Three-Dimensional Aerodynamic Optimization of a Multi-Stage Axial Compressor

Effect of Meridional Shape on Performance of Axial-Flow Fan

Design Optimization of a Supersonic Through-Flow Fan Rotor Based on the Blade Profiles

Multi-Objective Optimization for the Radial Bending and Twisting Law of Axial Fan Blades

The Matching Design of Back Vane for Rotor Blade Adjustable Axial Fan Based on AxSTREAM

Numerical investigation of the aerodynamic performance and loss mechanism in a low bypass ratio variable cycle engine fan

Design and Performance Analysis of a Two-Stage Transonic Low-Reaction Counter-Rotating Aspirated Fan/compressor with Inlet Counter-Swirl

Design of a Single Stage Variable Pitch Axial Fan

Multidisciplinary Design Optimization for Performance Improvement of an Axial Flow Fan Using Free-Form Deformation

Broadband Noise Reduction of a Two-Stage Fan with Wavy Trailing-Edge Blades

SUGGESTIONS OBTAINED FROM DESIGNS OF TWO HIGHLY LOADED FAN ROTORS

Numerical Investigation on Impact of Blowing Control in Flush-Mounted S-Shaped Inlet to Rear Fan-Stage Performance

Influence of diversified dihedral stator on the thermodynamic performance and flow loss characteristics of a variable core driven fan stage