Abstract:The modern compressor operation is challenged by the liquid presence in wet gas operating conditions. The liquid phase may affect the compressor stability by partially flooding the internal annular gas seals and inducing subsynchronous vibration (SSV). To improve the annular seal behavior and increase the rotor stability, high-precision results of leakage flow rates and rotordynamic force coefficients are needed for annular gas seals in wet gas conditions. In order to better understand the leakage and rotordynamic characteristics of the annular gas seal in wet gas conditions, a 3D transient CFD-based perturbation method was proposed for computations of leakage flow rates and rotordynamic force coefficients of annular gas seals with liquid phase in main gas phase, based on inhomogeneous Eulerian-Eulerian multiphase flow model, mesh deformation technique, and the multifrequency rotor whirling orbit model. Numerical results of frequency-dependent rotordynamic force coefficients and leakage flow rates were presented and compared for three types of noncontact annular gas seals, which include a smooth plain annular seal (SPAS), a labyrinth (LABY) seal, and a fully partitioned pocket damper seal (FPDS). These three seals were designed to have the identical rotor diameter, sealing clearance, and axial length. The accuracy and the availability of the present transient CFD numerical method were demonstrated with the experiment data of leakage flow rates and frequency-dependent rotordynamic force coefficients of the smooth plain seal with four inlet liquid volume fractions (LVFs) of 0%, 2%, 5%, and 8%. Steady and transient numerical simulations were conducted at inlet air pressure of 62.1 bar, pressure ratio of 0.5, rotational speed of 15,000 rpm, and inlet preswirl ratio of 0.3 for four inlet LVFs varying from 0% to 8% and 14 subsynchronous and synchronous whirling frequencies up to 280 Hz. The numerical results show that the inlet liquid phase has a significant influence on the leakage and rotordynamic coefficients for all three types of annular gas seals. The mixture leakage flow rate increases with the increasing inlet LVF, combining the decreasing gas-phase and linearly increasing liquid-phase leakage flow rates. The smooth plain seal leaks the most gas phase and liquid phase, followed by the pocket damper seal (PDS) and then the labyrinth seal. Increasing inlet LVF significantly decreases the direct stiffness and slightly increases the effective damping of the smooth plain seal. The labyrinth seal possesses evident negative direct stiffness and shows a noticeable decreasing effective damping with the increasing inlet LVF at the subsynchronous frequency range. Increasing inlet LVF obviously increases all the force coefficients of the pocket damper seal including the positive effective damping. From a rotordynamic viewpoint, the FPDS possesses a better liquid tolerant capability and so is a better sealing scheme for the balance piston seals and center seals of the centrifugal compressor in wet gas operating condition.

Numerical Investigations on the Leakage and Rotordynamic Characteristics of Pocket Damper Seals Part I: Effects of Pressure Ratio, Rotational Speed and Inlet Preswirl

Numerical investigations on the leakage flow characteristics of pocket damper labyrinth seals

Numerical Investigations on the Leakage and Rotordynamic Characteristics of Pocket Damper Seals Part Ii: Effects of Partition Wall Type, Partition Wall Number and Cavity Depth

Leakage Flow of Pocket Damper Seal at High Rotational Speed

Numerical Comparison of Rotordynamic Characteristics for A Fully Partitioned Pocket Damper Seal and A Labyrinth Seal with High Positive and Negative Inlet Preswirl

Experimental and Numerical Investigations on the Leakage Flow Characteristics of Labyrinth Seals

Effects of pressure ratio and rotational speed on leakage flow and cavity pressure in the staggered labyrinth seal

Effects of Gap Pressure Ratio and Rotational Speed on Discharge Behavior of Labyrinth Seal

Experimental And Numerical Investigations On The Leakage Flow Characteristics Of The Labyrinth Brush Seal

Leakage and Rotordynamic Force Coefficients of a Labyrinth Seal and a Pocket Damper Seal Operating with Wet Gas

Numerical Investigation on the Leakage and Rotordynamic Characteristics for Three Types of Annular Gas Seals in Wet Gas Conditions

Labyrinth Seal Rotordynamic Characteristics Part I: Operational Conditions Effects

Numerical Investigation on the Leakage and Static Stability Characteristics of Pocket Damper Seals at High Eccentricity Ratios

REVIEW OF THE LEAKAGE FLOW AND ROTORDYNAMIC CHARACTERISTICS OF POCKET DAMPER SEALS

Effects of Pressure Ratio and Sealing Clearance on Leakage Flow Characteristics in the Rotating Honeycomb Labyrinth Seal

Numerical comparisons of rotordynamic characteristics for three types of labyrinth gas seals with inlet preswirl

Experiment on Leakage Flow Characteristics of Labyrinth Seal

Labyrinth Seal Rotordynamic Characteristics Part II: Geometrical Parameter Effects

Numerical Investigations on Leakage Performance of the Rotating Labyrinth Honeycomb Seal

Experimental and Numerical Investigations of the Leakage Characteristics of Two-Stage Brush Seal

Numerical Investigations on Static and Rotordynamic Characteristics for Two Types of Liquid Hole-Pattern Seals With Tilted Cavities