Abstract:Mechanical and structural properties of rocks after failure are different from those of intact rock. The stability of surrounding rock in deep underground engineering is closely related to the post-peak state. By using the MTS815 rock mechanics testing system, rock specimens at different damage–fracture degrees were obtained through triaxial unloading testing of eight stress levels, including before peak stress, at the peak stress point, after peak stress, and at the residual stress stage. The damage–fracture degree was measured through changes in the elastic moduli of the specimens before and after damage. Considering the influence of irreversible plastic deformation on the damage of rock specimens, an apparent damage–fracture degree adaptive for describing the damage behaviours of rocks was proposed. The triaxial reloading test of damaged–fractured rock specimens under five confining pressure conditions was performed to reveal the influence rules of confining pressure and the damage–fracture degree of the peak stress, deformation parameters, strength parameters, and volume dilatancy characteristics of the specimens. The stress–strain curve of the damaged–fractured rock specimens with three-axis reloading after unloading at different stress levels exhibited five stages. A high damage–fracture degree of the rock specimens showed certain plastic deformation characteristics. The dilatancy phenomenon occurred easily in the volumetric strain of the specimens reloaded after unloading. The peak stress, residual strength, and elastic modulus of the specimens decreased, whereas Poisson’s ratio increased. The rock specimens with different damage–fracture degrees mainly exhibited shear failure. The greater the damage–fracture degree and the higher the confining pressure are, the relatively smaller the fracture angles of the rock specimens are.

Research on stress distribution of deep rock by mechanical impact parameters

Experimental Study Of Dynamic Mechanical Properties Of Rock Under Static And Dynamic Combination Load

Numerical Study on the Fracturing of Deep Rock Masses by Blasting Based on the Material Point Method

STUDY OF ROCK MECHANICAL CHARACTERISTICS UNDER COUPLED STATIC AND DYNAMIC LOADS

Excavation-induced deep hard rock fracturing: Methodology and applications

Experimental Study on Deformation Failure of Deep Rock Mass under High Stress Load

Experimental mechanical strength and deformation characteristics of deep damaged–fractured rock

Experimental study on the mechanical and failure behaviors of deep rock subjected to true triaxial stress: A review

Numerical Simulation of Zonal Disintegration for Deep Rock Mass under High Geostress

Experimental Study of High-Speed Particle Jets Impacting Deep Hard Rock under True Triaxial Stress

A method for assessing the risk of rockburst based on coal-rock mechanical properties and In-Situ ground stress

Field investigation and analysis of rockburst and spalling in a deep hard-rock mine

Study on Rockburst Proneness of Deep Tunnel Under Different Geo-Stress Conditions Based on DEM

Energy Evolution and Stress Redistribution of High-Stress Rock Mass under Excavation Distribution

Numerical study on the behavior of blasting in deep rock masses

Numerical study on the dynamic fragmentation of rock under cyclic blasting and different in-situ stresses

Dynamic Mechanical Properties of Porous Rock under Impact Loading

Numerical Simulation and Analysis of Rock under Hydraulic Fracturing Based on Acoustic Emission Monitoring

Experimental Study of Strain Rockburst Considering Temperature Effect: Status-of-the-Art and Prospect

THEORETICAL ANALYSIS AND EXPERIMENTS OF ROCK FRAGMENTATION UNDER COUPLING DYNAMIC AND STATIC LOADS

Study on Rockburst Mechanism and Prediction Methods in Deep Mining