Abstract:Abstract The NHR-200II is a multi-purpose small integrated pressurized water reactor (PWR). Its passive residual heat removal system (PRHRS) to remove core decay heat. During a series of PRHRS experiments conducted in a scaled integral test facility for the NHR-200II, a reverse flow phenomenon was observed. To study this phenomenon, a system model using the RELAP5 code was developed for the integral test facility, and the reverse flow phenomenon was numerically simulated. The system code was used to calculate the flow rate and heat transfer power of each RHE and PHE branch under the test conditions. The calculated flow rates in the PHE branches showed good agreement with the observed reverse flow phenomenon in the test facility. Similarly, the flow rate and heat transfer power of the RHE branch matched well with the experimental data. The cause of the reverse flow phenomenon is attributed to the asymmetric location of the RHE branch on the hot and cold headers relative to the PHE branches. The non-uniformity flow rates in the PHE branches are caused by the different distances between the RHE and each PHE branch. Although small initially, this non-uniformity is amplified by the positive feedback effect of pressure drop and flow rate between the PHE branches, eventually resulting in reverse flow. To address the reverse flow phenomenon in the PRHRS, two methods are proposed. The first method involves reducing the length of the ring header, while the second method focuses on increasing the buoyancy force of the natural circulation system. The effectiveness of these methods is calculated and discussed. This paper highlights the NHR-200II reactor PRHR system, discusses the observation of reverse flow in experiments, describes the numerical simulation using a system model, and proposes two potential methods to mitigate the reverse flow.

Analyses on Flow Instability of Passive Residual Heat Removal System for CPR1000

Calculation Analysis on the Natural Circulation of a Passive Residual Heat Removal System for IPWR

Analysis of Thermal Stratification Effects in the Ring Headers of the Passive Residual Heat Removal System of NHR-200-II

Analysis of Transient Characteristics and Design Improvement of the Passive Residual Heat Removal System of NHR-200-II

Study of One Design of Passive Residual Heat Removal System of Nuclear Reactor

CFD investigation on start-up transient of HPR1000 secondary side passive residual heat removal heat exchanger

Transient analysis and optimization of passive residual heat removal heat exchanger in advanced nuclear power plant

Numerical Simulation of the Transient Flow Characteristics and Thermal Stratification Phenomena in the Passive Residual Heat Removal System of NHR-200-II

Analysis of a Parallel-Channel Natural Circulation Loop in the Passive Residual Heat Removal System of the Nhr200-Ii Reactor

Investigation of Reverse Flow in the Passive Residual Heat Removal System of NHR-200II

Study on Limit Margin of Rising and Cooling Rate in Primary Circuit of CPR1000 Unit

Preliminary Investigation of THFR Passive Residual Heat Removal System

Analysis on Special Two-Phase Flow Instabilities at Full Power Natural Circulation Reactor Condition

Analysis of Passive Residual Heat Removal System of Modular High Temperature Gas-Cooled Reactor

Investigation on Thermal-Hydraulic Parameters and Instability under Two Different Heating Conditions Based on RELAP5 Code

Comparison and analysis on transient characteristics of integral pressurized water reactors

DESIGN AND FEASIBILITY ANALYSIS OF THE ELECTRICITY GENERATION SYSTEM BASED ON RESIDUAL HEAT

Study on Heat Transfer and Flow Instability of Supercritical Water in Vertical Tube

Thermal-hydraulic Stability Analysis of Nuclear Heating Reactors

A Multi-Scale CFD-system Coupled Code for Transient Analysis of the Passive Residual Heat Removal System of MHTGR

Numerical Study and Assessment of a Novel Combined Passive Cooling System for Tank-in-pool Reactors