Abstract:Single-stage boost-LLC ac–dc converters have been a popular soft-switched topology because of the high-efficiency and being cost-effective. However, low power capacity is its main disadvantage. In this article, a novel single-stage interleaved boost-LLC ac–dc converter with higher power capacity is presented while achieving the low input current ripple. However, it still suffers from the wide and high bus voltage for universal operation, as a result of the conventional pulse frequency modulation (PFM) with the duty cycle of 0.5. Furthermore, this wide bus voltage will bring the difficulties in designing the LLC resonant cell. To solve these issues, a dual-loop feedback control strategy based on PFM/interleaved asymmetric pulsewidth modulation hybrid modulation and power balance based optimal design are proposed. With the proposed control strategy and optimal design, the bus voltage of the studied converter is not only significantly reduced, but also zero voltage switching for the primary switches and zero current switching for the secondary diodes are still maintained. Thus, the higher efficiency can be achieved. Operation principles and control scheme for the studied converter are fully addressed. The optimal design based on power balance principle is also discussed in this article. A 300 W prototype is fabricated to validate the theoretical analysis and optimal design. The experimental results demonstrate the prototype can simultaneously obtain the universal operation with high power factor above 0.98 and the quasi-constant bus voltage below 500 V. The measured peak efficiency is 92.7% under 115 Vac input voltage at full load.

A novel control method for light-loaded multiphase boost converter with voltage multiplier used as a front-end of a grid-connected fuel-cell generation

Two-phase interleaved boost converter with voltage multiplier under APS control method for fuel cell power system

Three-phase interleaved high step-up boost converter with voltage multiplier for fuel cell power system

A High Step-Up DC to DC Converter under Alternating Phase Shift Control for Fuel Cell Power System

Applying Diode-Capacitor Voltage Multiplier to Coupled-Inductor Boost Converter for Novel DC-DC Converter with High Voltage Gain and Low Voltage Stress

A novel control method for dual mode time-sharing grid-connected inverter

Single-Stage Single-Phase High-Step-Up ZVT Boost Converter for Fuel-Cell Microgrid System

A Novel Hybrid PFM/IAPWM Control Strategy and Optimal Design for Single-Stage Interleaved Boost-LLC AC–DC Converter With Quasi-Constant Bus Voltage

A High Power Density 3-Phase/1-phase Compatible MISN-PFC Converter for On-Board Charger

An Improved Boost-Type Hybrid Converter with Multiple Outputs

An Analog Control Strategy with Multiplier-Less Power Calculation Circuit for Flyback Microinverter

Improved Control on the Complementary Half Controlled Three Phase PWM Boost Rectifier

Efficient Model-Free Predictive Power Control for Active Front-End Modular Multilevel Converter

A Novel Assorted Nonlinear Stabilizer for DC–DC Multilevel Boost Converter With Constant Power Load in DC Microgrid

Performance analysis of a single stage single phase high step-up soft switching boost converter

High Step-Up Interleaved Converter with Built-In Transformer Voltage Multiplier Cells for Sustainable Energy Applications

Interleaved Converter with Voltage Multiplier Cell for High Step-Up and High-Efficiency Conversion

A Current-Fed Dual-Half-Bridge-Based Composite Converter With Improved Light-Load Efficiency Through a Multi-Variable Optimization

A Four-Phase Interleaved Buck-Boost Converter With Changed Load Connection for the Fuel Cell Activation

Novel Five-Level Three-Phase Hybrid-Clamped Converter with Reduced Components