Abstract:In light-duty direct-injection (DI) diesel engines, combustion chamber geometry influences the complex interactions between swirl and squish flows, spray-wall interactions, as well as late-cycle mixing. Because of these interactions, piston bowl geometry significantly affects fuel efficiency and emissions behavior. However, due to lack of reliable in-cylinder measurements, the mechanisms responsible for piston-induced changes in engine behavior are not well understood. Non-intrusive, in situ optical measurement techniques are necessary to provide a deeper understanding of the piston geometry effect on in-cylinder processes and to assist in the development of predictive engine simulation models. This study compares two substantially different piston bowls with geometries representative of existing technology: a conventional re-entrant bowl and a stepped-lip bowl. Both pistons are tested in a single-cylinder optical diesel engine under identical boundary conditions. Utilizing high-speed soot natural luminosity (NL) imaging, 20 kHz time-resolved combustion image velocimetry (CIV) technique is developed to quantify the macro-scale motions of soot clouds during the mixing-controlled portion of combustion. Under a part-load conventional combustion regime, CIV-resolved swirl ratio and the tumble-plane projection of velocity fields confirm that the injection-induced redistribution of angular momentum, rather than squish/reverse squish flow, is a dominant source for swirl amplification between two piston geometries. A strong connection has been found between the CIV-resolved combusting flow structure and its succeeding enhanced late-stage burn rate. With SOImain shortly after TDC, combustion in stepped-lip piston exhibits shorter late-burn duration (CA50-CA90) and faster burn rate compared to re-entrant piston. In the same boundary condition, a unique combusting flow structure is observed with CIV in the stepped-lip piston: a long-lasting flow structure with opposing radial velocity directions between the squish region and stepped-lip region. Interestingly, this flow structure is never optically observed with the re-entrant piston. The best hypothesis is that there exists a long-lasting vertical toroidal vortex on the shoulder of stepped-lip piston crown near CA50. A phenomenological model is proposed to provide a partial, but valuable picture of late-stage combusting flow structure which is a key to understand how piston bowl geometry can influence thermal efficiency for swirl-supported diesel engines.

Imaging Studies of In-Cylinder HCCI Combustion

Experimental Setup of Combustion Visualization Inside a Heavy-Duty Diesel Engine Converted to Natural-Gas Spark-Ignition Operation

An Experimental Investigation of Early Flame Development in an Optical Spark Ignition Engine Fueled with Natural Gas

Optical Study of Flow and Combustion in an Hcci Engine with Negative Valve Overlap

Investigation of Multistage Combustion Inside a Heavy-Duty Natural-Gas Spark-Ignition Engine Using Three-Dimensional Computational Fluid Dynamics Simulations and the Wiebe-Function Combustion Model

Control of HCCI Combustion in a Two-Cylinder GDI Engine with Negative Valve Overlap

Computational Fluid Dynamics Simulation of In-Cylinder Flows in a Motored Homogeneous Charge Compression Ignition Engine Cylinder with Variable Negative Valve Overlapping

Effects of spark ignition and stratified charge on gasoline HCCI combustion with direct injection

Analysis of ion current signal during negative valve overlap of HCCI combustion with high compression ratio

Control of Homogeneous Charge Compression Ignition Combustion in a Two-Cylinder Gasoline Direct Injection Engine with Negative Valve Overlap

Visualization and Performance Analysis of Gasoline Homogeneous Charge Induced Ignition by Diesel

Experimental and Computational Studies on Gasoline HCCI Combustion Control Using Injection Strategies

Effects of active species in residual gas on auto-ignition in a HCCI gasoline engine

Operating Characteristics of a Homogeneous Charge Compression Ignition Engine with Cam Profile Switching - Simulation Study

Combustion Visualization and Experimental Study on Spark Induced Compression Ignition (SICI) in Gasoline HCCI Engines

An Investigation of the Presence of Uncontrolled Combustion Phenomenon in Spark Ignition Single Cylinder Optical Engine

Research on steady and transient performance of an HCCI engine with gasoline direct injection

A Modelling Study into the Effects of Variable Valve Timing on the Gas Exchange Process and Performance of a 4-Valve DI Homogeneous Charge Compression Ignition (HCCI) Engine

The Relationship between In-Cylinder Flow-Field near Spark Plug Areas, the Spark Behavior, and the Combustion Performance inside an Optical S.I. Engine

New Gasoline Homogeneous Charge Compression Ignition Combustion System Using Two-State Direct Injection and Assisted Spark Ignition

A Study of Piston Geometry Effects on Late-Stage Combustion in a Light-Duty Optical Diesel Engine Using Combustion Image Velocimetry