Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Reduction of load model based on perturbation method

Comparison of three composite induction motor load models

Load Modeling with Considering Frequency Characteristic

Dynamic equivalent method of interconnected power systems with consideration of motor loads

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Modeling and Simulation of Non-Linear Dynamic Process of the Induction Motor System with Fluctuating Potential Loads

Sequential Parameter Estimation of a Simplified Induction Motor Load Model

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

Analytic Formulae for Estimating Motor Proportion of Load Model under Small Disturbance

Practical Induction Motor Model with Consideration of Frequency Variation

Parameters identification of practical load model with voltage phase considered

Identification of a composite load model with applications

Load Modeling Including Air Conditioners

A new generalized load model of power systems and its applications

A Model Order Reduction Method for Nonlinear Multi-time Scale Systems

STUDY ON THE ORDER REDUCTION OF TWO-TIME SCALE POWER SYSTEM DYNAMIC MODELS: Part One Power System Singular Perturbation Model

Simulation and Dynamic Modeling of Induction Motor in Ship Electric Load

Reduced Order Modeling for Load Aggregation Based on Empirical Covariance Matrices

Summary of Singular Perturbation Modeling of Multi-time Scale Power Systems

Stability Discrimination and Load Shedding Control of the Induction Motor

Load Models for Modeling Dynamic Behaviors of Reactive Loads: Evaluation and Comparison