Abstract:Supercritical CO2 (S-CO2) power cycle has been widely applied in the field of nuclear energy, solar energy and waste heat recovery because of its high efficiency, compact structure and suitability for various heat sources. Compressor and turbine are the key components of the S-CO2 power cycle which significantly affect the cycle performance. Therefore, it is of great necessity to carry out the cycle optimization design and key components performance analysis.In this paper, a novel system-component coupled optimization method of S-CO2 power cycle, which fully considers the performance of compressor, turbine and the S-CO2 power cycle performance, is proposed for improving the accuracy of optimization design results and guarantee a good match between the optimal thermodynamic parameters of S-CO2 power cycle and the performance of key components. The system-component coupled optimization method is implemented by genetic algorithm based on the one-dimensional model of the S-CO2 centrifugal compressor and S-CO2 radial inflow turbine to obtain the accurate optimal cycle thermodynamic parameters and the key components design parameters. Using the obtained design parameters of S-CO2 centrifugal compressor and S-CO2 radial inflow turbine, three-dimensional modeling and CFD simulation of S-CO2 centrifugal compressor and S-CO2 radial inflow turbine are implemented. The results show that using system-component coupled optimization method can evaluate the cycle performance more reasonably and accurately. The optimized cycle thermal efficiency and the cycle net power output are 19.47% and 987.3 kW, respectively. The optimized turbine efficiency and compressor efficiency are 82.57% and 81.25%, respectively. Unsteady CFD simulation results show that the turbine total-to-total efficiency obtained by steady computation is 0.83% higher than the unsteady time-averaged value obtained by unsteady computation. The relative errors of one-dimensional design results and three-dimensional simulation results for both compressor and turbine are within 5%.

Performance Analysis of the System Coupling Gas Turbine and CFB Boiler

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

ANALYSIS OF RETROFITTING SCHEME FOR A COMBINED CYCLE WITH BOILER USING EXHAUST GAS FOR SUPPORTING COMBUSTION

Design and performance analysis of compressor and turbine in supercritical CO2 power cycle based on system-component coupled optimization

Performance Analysis of Biomass Gasification Coupled with Ultra-Supercritical Power Generation System

Thermodynamic Analysis of a 660 MW Ultra-Supercritical CFB Boiler Unit

PERFORMANCE COMPARISON OF GAS TURBINE CYCLE COMBINED WITH SUPERCRITICAL CO2 RECOMPRESSION AND REGENERATIVE CYCLE

Modeling and thermal economy analysis of the coupled system of compressed steam energy storage and Rankine cycle in thermal power plant

Performance Evaluation Case of a Gas Turbine-based Heat-and-Power Cogeneration System

Study on coupling performance of turbo-cooler in aircraft environmental control system

Model and Validation of the Thermodynamic Cycle Calculation for a Three-Shaft MW-Level Gas Turbine

Simulation Investigation on Performance of a Power–water Cogeneration System Coupled with a Two-Stage Thermal Vapor Compressor

STUDY ON MODEL OF CFB MULTIPLE CO- GENERATION AND PERFOMANCE PREDICTION THEREOF

Analysis of Transplanting Turbofan Engine Technology to Reducing Power Consumption Rate of Thermal Power Unit

Thermodynamic and Economic Investigations of Transcritical CO2-cycle Systems with Integrated Radial-Inflow Turbine Performance Predictions

Analysis and Improvement of a Two-Stage Centrifugal Compressor Used in an MW-Level Gas Turbine

Performance analysis of turbine extraction superheat utilization schemes of built power plant

Theoretical Investigation on the Partial Load Feedwater Heating System with Thermal Vapor Compressor in a Coal-fired Power Unit

Numerical Investigation on the Impact of Exergy Analysis and Structural Improvement in Power Plant Boiler through Co-Simulation

Energy and Exergy Analyses of an Improved Recompression Supercritical CO2 Cycle for Coal-Fired Power Plant

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model