Abstract:SMA is a gap graded mix composed of a high concentration of coarse aggregate that is held together in a thick asphalt film by a matrix of mineral filler and stabilizers. Since natural aggregates have become expensive, hence Reclaimed Asphalt Pavement (RAP) can be reused in pavement construction to reduce the environmental hazardous due to disposal problems. Since the RAP contains used aggregates, it is highly prone to fatigue, thermal and reflective cracking effect. Rheological and chemical properties of aged bitumen in RAP can be enhanced by use of untreated waste oils such as waste engine oil as rejuvenators. This research presents a study on fatigue performance of SMA mix with Reclaimed Asphalt Pavement (RAP) materials with and without rejuvenators and results were compared with conventional SMA mix. The materials used were first characterized by common laboratory tests. Then the three SMA mixes are tested using several laboratory test procedures: Marshall Stability, indirect tensile strength, moisture susceptibility, and indirect tension fatigue test. The optimum proportions of the of the mixes with highest stability are selected from the Marshall stability test. The indirect tensile strength test results show that the SMA mix replaced with RAP without rejuvenators showed higher tensile strength ratio and resistance to moisture damage when compared to conventional mix and optimum RAP replacement mix with rejuvenators. The fatigue test was conducted for the three optimum mixes at different temperature and stresses. The fatigue test results showed that at lower temperature and stresses, the RAP replaced SMA without rejuvenator offered better fatigue resistance than those with rejuvenator and conventional SMA mix. At higher temperatures, the RAP replaced SMA mix with rejuvenator offered similar fatigue lifecycle as conventional mix. However, at high stresses, conventional SMA mix offered better fatigue lifecycle. Increase in failure stresses resulted in decrease of number of fatigue cycles and increased in initial tensile strain of the mix. Thus, with the use of RAP substantial decrease in cost can be achieved without compromising the fatigue characteristic of the SMA mix.

Mix Design and Performance of Crumb Rubber Modified Asphalt SMA

Laboratory evaluation on performance of crumb rubber SMA

Evaluation of Performance on Crumb-Rubber-Modified Asphalt Mixture

Performance Evaluation of Dense Mixtures with Stabilised Rubber Modified Asphalt

Performance Evaluation of Crumb Rubber Asphalt Modified with Silicone-Based Warm Mix Additives

Laboratory Study on Properties of Tire Crumb Rubber Modified Bituminous Mixture

Preparation Technology and Performance Analysis of Crumb Rubber and Sbs Composite Modified Asphalt Binder

Evaluation of Fatigue Potential for Crumb Rubber Modified Bitumen in Stone Mastic Asphalt Mixes

Analysis of the Influence of SBS Content and Structure on the Performance of SBS/CR Composite Modified Asphalt

Investigation of the Effect of Crumb Rubber Powder and Warm Additives on Moisture Resistance of SMA Mixtures

Effect of Mixing Sequence on Asphalt Mixtures Containing Waste Tire Rubber and Warm Mix Surfactants

Evaluation of the influence of warm additives modified by Vestenamer polymer on the performance of stone matrix asphalt containing crumb rubber

Properties of Warm Mix-Recycled Modified Asphalt SMA Mixture

Quantitative assessment and mechanism analysis of modification approaches for cold recycled mixtures with asphalt emulsion

Modification of the Dry Method for Mixing Crumb Rubber Modifier with Aggregate and Asphalt Based on the Binder Mix Design

Investigation into the Rheological Properties and Microstructure of Silt/Crumb Rubber Compound-Modified Asphalt

Performance of the SMA mixes made with the various binders

Study on the performance and sustainability of modified waste crumb rubber and steel slag powder/SBS composite modified asphalt mastic

Experimental Study of Stable Crumb Rubber Asphalt and Asphalt Mixture

Study on the Properties of Waste Oil-Activated Crumb Rubber-Modified Asphalt Based on Molecular Dynamics Simulation and Rheology

Design and Performance Evaluation of Cold Recycled Mixture with Emulsified Asphalt